Recent content by onyxaltezza

I had that as well, didnt work out well. I always have to transport stuff in my car and using the dual ported prefab sat right against the back of my trunk, blocking the whole area that I could use my foldable rear seats for. So I wouldnt be able to carry stuff and extend it into my cabin.

Hey guys- So I currently have 2 of these. Specs here: RE Audio SEX10D2 (SEX10-D2) 10" Dual 2 ohm SE-X Car Subwoofer I have the powered with an Alpine MRD-M1005 at 2 ohms sending 1000W RMS. They are each enclosed in ported enclosures of 1.25cu ft, each seeing about 500RMS(at 14v), and tuned...

Ok, understood. However, how do I merge the signals for the mids and lows(sub out)? I know which wires are which, I just cant figure out a way to combine 2 mid channels & 2 low channels together, into a total of 2 channels?

Alright Im having some issues adding midbass drivers to my 2012 BMW 5 Series. The sub outs on the factory amp are crossed over at 58hz. I have a line out converter tapped to the factory sub out wiring -> mono amp -> Pair of 10" subs. Low end sounds great. Now I dont want to change out...

Sigh :[

Anyone else have input?

Oh I wasnt actually pointing to anything, I was just holding it at an awkward angle lol. In that pic I was just trying to depict the fact that there is burn on the actual board. All dark marks are only visible on the housing...btw are MOSFETS replaceable? It looks like its the #5 one...

All you gurus and no one has input? =\

Before you say I told you so, yes, I bought this amp used off Craigslist about 2 months ago. Bad idea to not test it on the spot, I know... I didnt have a chance to throw it in til yesterday, but when I ran all the cables, etc, it powered up, digital display came on, but no power to subs. The...

Oh ok, I get this concept now. If I set my mids to 125hz and my lows to 80hz, then between 80-125hz it would leave a gap and sound kinda hollow sometimes and uneven? This never occurred to me. Thanks guys! -Aaron

Also, is it normal that when adjusthing HP/FP and frequencies on the SPEAKER amp, it affects SUB output too?! I thought each amp controlled its own features for its own speakers. -Aaron

I set amp and deck to HPF at 80 and on the way to school i noticed that i get more distortion now compared to before when i had the amp set at full pass 100hz and the deck at HP 125hz. My subs arent hitting as hard either. For some reason my subs hit better when i set them at 125hz on my deck...

Ok, I kinda comprehend that now, but on the bottom 2 charts, how does each sound? Like can you explain how a wider curve would sound compared to a narrow curve? I just tried messing with the settings and i dont hear too much between the 2. -Aaron

He is powered by an MRV-F240 I sold him a while ago buddy.

Ok cool, and someone has gotta explain to me the wide/narrow settings. Or at least tell me in super simple terms what narrow or wider sounds/will sound like. plzzzzzzzzzz (= -Aaron