Recent content by OneMeanS1x

Bump!

When i bridge them to a 2 ohm load bridged, it sounds like only half the amp is working. When i run each woofer to each terminal (one woofer to positive and negative on one side of the amp and one woofer to positive and negative on the other side) they are ran at 4 ohms, and at high volumes the...

it goes into protect with 2 seperate channels at 4 ohms each but not with one channel with 2 ohms.

I have 2 15.2 Orion H2s and a Crossfire VR2000D. The amp is rated at 2000x1 at 2 ohms and 1000x1 at 4 ohms. So overpowering it shouldnt be an issue at all. I dont think its wired incorrectly either. It doesnt say if thats per channel or bridged or what. it is a mono block amp. I have the subs...

One of my subs sounds like it has a slight rattleing inside of it. its not a screw, or something on the car, for when i push on the dust cover a tad bit, it goes away at low volumes. Any idea?

Hello, I have a crossfire vr2000d for sale in good condition, never been abused and works great. I just got 2 Orion 15 H2s from HCCA fan. They are 2000w RMS a PIECE so it turns out I need a more powerful amp. Im looking to get one thats around 5000w peak 4000w RMS @ any ohm configuration. Im...

The amp is listed as a monoblock amp on crossfires website, and in the instruction manuel, yet it has 2 terminals, like a stereo amp, 2 positives and 2 negatives. My subs are DVC 2 ohm.

The only possible thing I can think of is that I only have a single battery, factory alternator, and 4ga wire ran, but I dont know why this would cause the amp to go into protect. Please advise.

Here is my situation. I have 2 15.2 Orion H2s and a Crossfire VR2000D. The amp is rated at 2000x1 at 2 ohms and 1000x1 at 4 ohms. It doesnt say if thats per channel or bridged or what. it is a mono block amp. I have the subs wired as a 4 ohm load indepdently, and they are wired as a 2 ohm load...

Wow. Thank you so much for your help and shareing your knowledge on this subject. The box is a single chamber. The only thing is, i noticed this within 2 minutes of putting power to to the woofers. When i push on the center, i notice no resistance what so ever. As for the xmax, this woofer...

Heres my problem. I used to have 2 diamond audio 15cm3s hooked up to a crossfire vr2000d. It hit hard as hell, then one day it sounded about half as loud, and I noticed one woofer was hitting a split second after the Right. The port is on the right as well, and while i heard its normal for this...