Recent content by Onebadaudi

  1. O

    Pioneer avh-p4200 rca pre out problems

    Interesting.ha i was actually reading about that fuse earlier on the site..is that fuse soldered in the board..is it something that can be replaced or is it a manufacturer fix? Thanks
  2. O

    Pioneer avh-p4200 rca pre out problems

    I seem to be having some issues with the head unit. I have 2 amps, one for the components(JL c2605s) and one for my sub(13.5 w7). The beginning issue was when i had the volume on anything higher than 10, i would lose all of my speaker volume but the bass level remained the same. It was as if i...
  3. O

    Alternator question

    ^ Thanks I talked to Quality powered autos and they make HO Audi Alternators (250) and i asked what the Idle output was and they said 140amps, and 250 at 2200 rpms. Perrrrrrrrrrfect So im gonna blast and be smart until my alt dies, then pick one of these bad boys up.
  4. O

    Alternator question

    ^^ **** 14.5, thats what im talking about. Glad to know about the stock alt to...thanks im curious if they make a alternator for my car, that is a issue i have been running into.
  5. O

    Alternator question

    O im sure the alt wont last. Im curious to see how low can she go:naughty:
  6. O

    Alternator question

    thanks for the input, im going to put in the 1000/1 and stick a volt meter on my batterys and see how bad the draw is going to be. Im going to do it with the lights and heat on and no lights or heat on. See what my results yield
  7. O

    Alternator question

    Firstly, problem fixed about the light issue- Amp was clipping like a mother. Second, heres my question --Setup-- 2002 audi b6 a4 Pioneer avh-p4200dvd Head unit 2 Sets of Jl Audio c250 components 12 w7 in prowedge box 500.1 Jl amp (soon to be 1000.1) mtx jack hammer JH404 4 channel for...
  8. O

    Guys, I am at a loss(need help)

    Since the install. ****, i knew i forgot to do something tonight haha. Putting it on my list of things to do 2moro.
  9. O

    Guys, I am at a loss(need help)

    Hey guys, sorry, i have been swamped at work this week. I will pull the amp down 2moro and take a pic of the settings. On a side note, i got tired of the 10 w7, returned it and got a 12 w7 now. The 500/1 dosnt do justice for it although it is louder. 1000/1 is coming soon, so im almost positive...
  10. O

    Guys, I am at a loss(need help)

    Output mode is full range. The amps are grounded to the aux battery terminal and the battery ground is to clean metal I know a HO alt has more amps, does the idle output increase as well? Also I'm having trouble finding a comp that will make one for an audi. I talked to ohio generator and he...
  11. O

    Guys, I am at a loss(need help)

    The second battery is a shuriken 20 amp battery. its ran with 4 gauge. Its wired as if it were a cap. The JL amp is wired to that battery. The whole setup is ran in 4 gauge. I have not done the big 3 yet. i was looking at the cables under the hood and they are either 4 or 6 gauge wire so i...
  12. O

    Guys, I am at a loss(need help)

    Im near cape may courthouse. Very south jersey That does make sense, How do i go about stopping this?
  13. O

    Guys, I am at a loss(need help)

    The W7 is in a sealed prowedge box, The Mtx amp is not the problem. The lights do not dim when the JL amp is off. When the mtx amp is the only one running, my lights dont dim at all. Its only when the sub pushes the higher bass notes. The components run fine and there is no dimming coming from...
  14. O

    Guys, I am at a loss(need help)

    Well I turned the IF off and turned the lp to 24db and set at 80 n lights still dimming on highs. Any other ideas?
  15. O

    Guys, I am at a loss(need help)

    Thanks again. The amp is set at 12db( 24db makes the sub very quiet) I have the knob set to 65hz
Top