Recent content by NINYO

tru! i remember when i 1st got it, it was kinda like 1.5ohm y 2.5ohm. so what could have caused this?

its reading 3.8ohms on one and 2.1 ohms on the other. when i first got it (from sonic electronix) it used 2 show diffrent readings like it is now, but when it was wired up, they kinda evened out.

1 moment. its right here lemme test it now

its a dual. so what could be the possible factors why its showing a 2 omh(1.5ohm) load when its wired 2 a 1ohm?

what u mean? is it a blown sub?, it used 2 work perfectly till the bass started getting cut off, now its dead for ever. coz its a single sub, i can only wire it parallel - 1 ohm or series to 4ohm.

I gotta PSW912 single alphasonik sub. wired up at 1ohm. after having problems with the system, i decided to check the sub with a multimeter to see if its blown. my reading was 1.5ohms. is this normal if its wired up at 1ohm? thanks. and help would be appreciated!

could it be a problem with the ground even if the amp is powering on?

Hey guys i hope u can help me out! I gotta alphasonik PMA1200DA amp and a alphasonik PSW912 SUB connected 2 a alphasonik 5fared cap running at 1ohm am using a audio control matrix as a line driver and also a epicentre. When i first installed the system i was told 2 keep the gain to low and if...