Recent content by newbie101

Throw me some ideas, I had the amp mounted to the back of the back seat, I just got a new amp. The mounting holes dont match up, and I dont want to drill any more holes in my seat. I though about mounting a board to match the old holes, and then mounting the new amp to that. Does that sound like...

thats what i thought, and was hoping for...So the wires I have are basically 2 wires seperate, but in the same coating, with 2 ends on each side + and -. I need 2 of those for each speaker right? if so, then the wire from the speaker to the amp has 4 ends instead of 2. Do I twist the + together...

I really dont know...you gonna laugh, but what is a coil??? the wire connector on the speakers have 4 tabs each. Only 2 in use with the wire setup it has. I have an ohm tester I think they read 2 ohm , but not sure its very touchy and I dont really know how to use it right, so many dials. Im...

I havent asked what he did yet, but ive been researching...One thing i saw said power and rca's should be ran on opposite sides... transistors, ohms...sounds like it could be anything..I just home the amp isnt fried

the amp is wired low? or the speakers? How can i change either of the 2? ****ing best buy..

Well the gain was 3/4, then I switched to 50% turned bass down....The first time it happened, i was messing with my stereo's eq mid's.. And I know best buy sucks..But ther isnt too much around here, there only other place the guy was shady...Went in for install guy tried to Have me give him my...

Ok I got an old MTX Blue Thunder Pro 3200 i think I have 2 12" Alpine Type E Got them off a trusted friend, says it all works fine. Had the Install done at Best Buys, 4 gauge wiring kit. Worked fine on the ride home. next trip everything stops working. The amp is real hot. It will work if...