Recent content by Morts

Great Amps I have one and was wondering if you had a copy of the manual?? Free Bump

I need a 2 ohm final load. Thanks for the offer.

OK guys I need some 10 or 12s for a D300-HC. Here is what I need. I want subs that will sound good in a small sealed enclosure, the smaller the better. More SQ than SPL, I am doing a stealth install and dont want to tie up the whole trunk with subs. I would not be against even 1 sub but I get a...

109 a piece at Sonic Electronics

Anybody run them? I looking for some 10s that I can used in a sealed box on the cheap. The specs say sealed is the best to run these. Going to run about 1,400 RMS to the pair. Any input appreciated. Pioneer USA - Champion Series PRO

How close to Buffalo are you?

OK guys I need a decent Hi/Low converter for a factory HU. I need to have 3 sets of inputs for front/rear and sub. I seen the jl cleensweep but it only has 2 sets of inputs for amps and I need 3. The audiocontrol LC6i seems to have what I need and then there is the Hifonics MX-1 has anybody have...

Check wiring of the subs again. http://akamaipix.crutchfield.com/ca/learningcenter/car/subwoofer_wiring/2DVC_2-ohm_mono.jpg I didnt realize it was a mono amp before

I have not got these tweeters yet they are in the process of being shipped to me. I am not going to run a passive crossover at all with them. Just need a safe crossover point for them I guess and want to play them as low as I can and be safe. Hope I cleared it up now and I appreciate the input guys.

They are Morels Here is the spec sheet. Appreciate the input. http://www.renaudio.com/sale/MDT-105s.pdf

It is indeed a 12dB/octave x-over. The tweeters are run separate on 2 of thier own channels 1 and 2, my mids are on channels 3-4 and the sub is bridged on channels 5-6. So I will not need any passive crossovers and if I set the crossover at 3.5K I am safe? I never ran a tweeter without a...

OK I am a little confused here. I have always used tweeter crossovers even after an active crossover. I just got a new set of tweeters and they are 6.4 ohm and have no crossovers with them. I have an old HiFonics amp with 2 crossovers built in the amp, one for low/mid and the other for mid/high...

Hello I am a newbie here and have a couple of sub questions. 1) I have a J/L 12W3v3 coming tomorrow to finish my first build. I was wondering if anyone can tell me if they run one of these subs in a trapezoid truck box? I didnt look at the mounting depth and noticed its a bit larger than the...