Recent content by mirrortints

Thanks, I've got just too much time to think. Waiting on my subs to ship.

Cool, thanks! Also wondering, better to run each sub in series, inside the box, then parallel outside. So, bringing impedance up, then down. Or, parallel inside, then series outside. So, bringing impedance down, then up. I always thought going with the higher impedance, first, is best, then...

So, I have "2" 2 ohm dvc subs in separate chambers, not connected to each other. I run the in series inside the box. Now, I have a set of terminals on the back of the box, for each. If I want to run them parallel, do I? A) run a + to the other +, and a - to the other -. Then run one set of...

Thanks, after some research, I think 2 IA DP15s will work for me.

I was going to go with Sundown, but looking for something made in the usa and good quality. I am having a mini wall for my back seat. Will be between 4-5 ft^3 each chamber (2 total). I will be using a Taramps Smart 3 amp. I was looking at fi audio, but any other suggestions? I see Adire and RE...

I used 2 Deka marines, I prefer the 4 posts. 1 under the hood, other in the trunk. Not sure on if I want a battery isolator, but keep your batteries about the same. These were about $90 each. Find a dealer close to you. Sent from my SM-G955U using Tapatalk

Ok, first time using a mb quart amp. Does the Level look normal? Never seen it go from high voltage to low voltage. Sent from my SM-G955U using Tapatalk

I have had this subwoofer for a few years and am looking to rebuild it. When I called ID, they said it was pretty easy to recone and I found the kits, but how is this done? Local places want $100-150 to recone (not including the recone kit), which, in the end, will make this cost more than just...