Recent content by millerb415

here is my set up infinity kappa 60.11cs front, kappa 6x9, alpine pdx-v9, and an alpine sub. was debating about whether or not to run the 60.11cs active on the amp or to run them passive using the crossovers that came with the speakers, and powering the back speakers also. what would you recommend?

i was planning on placing one on each side of the trunk in separate boxes each with enough air for one sub

i use my car for moving in and out of school apartments so i want to keep as much trunk as possible

i am looking at getting some new subs for my car, i was debating between ether getting 2 of the jl audio tw1 12 inch or one tw3 it will determine what amp i am getting so i was wondering what would give me the best sound quality i am placing them in a toyota camry so not a big car, matched with...

do you think it is worth the money to get a better quality amp like a Rockford Fosgate Punch P1000X2 and then save up/ wait for the audio control 6 channel amp/ equalizer to come out and then get that and use the Rockford Fosgate Punch P1000X2 bridged for a sub?

was also looking at the AudioControl LC-6.1200 an then bridging the channels together to get the needed power for the 900s

the one problem with that is if i go three way on them (which i plan to) the rms is now 175 or if i go with the 900 it is now at 225 way to much for that pioneer. or am i doing the math wrong? and i am planing to use the other two channels to run base and then rears later so bridging them is a no go

then what would you recommend?   ---------- Post added at 08:25 PM ---------- Previous post was at 08:25 PM ----------   what would you recommend then?

Im looking at getting some kappa perfects want to set them up using a three way crossover but do not know how much power to give them i know that the 600 wants 100 rms and the midrange wants 75 rms so 175? but there is not really any amp offering the that power only the power from rockford...

was looking at getting this amp but was wondering how bad the overheating problem with it is, i am building my system and it will have some milli legend 6.5 in the fround and ether audison voce 6.5 (200 local shop) coax in the rear or another set of millis (getting a deal on them from my local...

i am replacing the factory speaker wires with better quality wire for my amp, but do not know how much to get i need to make 5 (4 replacements and one new for base) runs from my amp and i have a toyota camry i was looking at about fifty feet but do you know a more exact num

was looking at the kenwood DPX793BH is it any good? or would you recommend anything else for the price

i was more trying to see if that is a good deal or not i know that there are too many factors for a sound board to recreate and thus they will sound different in my car

i was looking at hertz there is a dealer by my house. but they do not carry the full line but they will sell me audison premas for 350 is that a good deal and would you go with that?

yes components and 6.5