Recent content by mikeysheff12

I’m looking into getting a recone kit for my zvx2 but I don’t know too much about the specifics and what to look for when getting a recone kit, or where to look into for getting one

Alright, good deal. I’ll find some metal tomorrow and do it

How long would I have to do it for?

Oh no I haven’t. I’ll do that when I can get my hands on two bars of metal. Right now I already have the bank built in series with the bus bars connected and everything

How do you passive balance them?

So something like this? https://heltec-bms.com/project/3s-4s-5a-active-balancer-capacitance-with-v1-8-copper-nose-wire-connector/ also what if I have this problem with this next balancer, I figure it would be a problem with the lithium bank but I’ve measured all of the cells and they all range...

https://rover.ebay.com/rover/1/711-53200-19255-0/1?icep_ff3=2&toolid=10001&campid=5335951755&icep_item=264538084775

So I built a headway bank, all of the polarities are correct. I went off of a YouTube video after doing a ton of research on lithium and headway cells specifically. But I’m trying to connect the balancer, connecting the negative first and then going through the bank, adding the positive on the...

I do plan on getting a HO but that’s a bit far in the future. I won’t be going over 4kW anytime soon at all. My next plan for a build is a 3kW rms but still, that’s kind of far ahead. When the time comes, I’ll build a new bank if need be but that does make a ton of sense, thank you

I do understand stand it to a point. I have 4 wires from by original positive terminal that need to go into the fuse block (2 of them are 1/0) and then only 1 1/0 wire leading out. Then my negative terminal I need another fuse block I think to put 1 1/0 and another wire (4 gauge I think) into...

Also I can’t find any fused distribution blocks that aren’t over $50 that have 4 1/0 gauge inputs and at least 1 1/0 output

I’m not that good with diagrams so it’s a little hard to understand that. So I could get a fused distribution block, take all four wires from my positive terminal and put it into the fused block. What if some of them don’t need to be fused, should I still put a fuse in place or what do I do...

Exactly what I was thinking, I plan on to keep upgrading and climbing in wattage when I can with bigger amps, bigger subs, so why not set a ground basis for it by doing an overkill on the supply. I was thinking about deleting my stock battery and putting a distribution block there, the only...

I read that and I’m still a little bit confused, I don’t want to get an isolator unless I have to and I don’t necessarily want to delete my stock battery so the only option on that website is to wire it straight to the alternator. My question is where would you put the negative then and...

Alright. Only one more question. How do I wire it up. Do i wire it straight from my battery just like you would a secondary battery