Recent content by mickskillz

I just blew one of my crossovers from my diamond audio hex s600a series components and need some new speakers asap. I don't really wanna spend more than 350 on the set. I like something a little less harsh than the diamonds, and something with better mid bass. I need some suttle soft tweeter...

Dude I'm in the same boat... Those are probably the same ones I'm gonna get... I'm gonna power them with a JL 300/4.... Was using diamond audio hex s600 series and i think i just blew one of the crossovers. Let me know what kind of deal he can get us. Thanks

I've installed a 500/1 using stock deck and a navonne converter in my g35.. pushing a ten inch rockford p3 .... how should i connect the rca's on the amp and should i have the amp input selector in high or low position.. also if i put both the rca's on the amp at the same time.... the sound is...

i have two jl amps hooked up.... a 300/4 and a 500/1... running 4ga from battery fused at 60 amps and then to a distro block with each amp fused at 60 amps again... i'm only pushing one ten inch sub and when the bass hits hard the 500/1 shuts off... the only way it goes back on is when i pull...

which ten inch sub should i get... i have a jl audio 500/1 and i have the box already which has .85 cubic feet of airspace and a mounting depth of 6 7/8.... please help .... i currently have a punch 3 right now and it's not enough bass for me... thanks

does anyone know if this amp has an internal fuse...????

be very careful with soundstream's newer amps..... they do put out the power listed although they are known to have a faulty power supply and come DOA from many of your ebay vendors HINT(indoaudio) good luck

i have the diamond audio hex s600 and i'm currently pushing them with a jl 300/4... bridged giving each set 150 watts.... they sound unreal.. go with a jl 300/2 or /4 http://www.acaraudio.com is blowing out jl amps...

I have a jl 300/4 in my vehicle.... it's currently running off my stock headunit with a 4 channel line output converter... i have the front two channels running in stereo pushing a set of diamond audio hex series s600's and the rear two channels bridged pushing a rockford fosgate p3 10 inch...

i need a 4 channel amp for a set of diamond audio hex 600s in the front and a single 10 inch rockford p3 sub in the rear..... please send me some suggestions on which amp will give me enought power for the two

check what ohms your subs are and try this link speaker wiring....click here also check and see what ohm your amp is stable at...hope this helps

jl amps are underrated and will give you much more clean power than the alpine.... although it's only for a subwoofer so it wouldn't make too much of a difference which one you go with..... if you are on a budget go with alpine, otherwise jl is where it's at

i would check your ground.... make your ground cable as short as possible..... no longer than a foot and 1/2.... also while the static sound is coming through i would move around my rca cables.. see if that makes the static change a bit... try good cables.. http://www.kunkonceptz.com has some...

i'm looking at getting a h/u that has a dvd screen and plays cd's... looking for something in the cheaper range... any suggestions...

tried that already... i think the amp has an internal malfunction..... this sucks