Recent content by medeiro

  1. M

    SOLD Fs: Jl w7 13.5 jl 1000/1 $800

    I am selling my W7 and 1000/1, Zero gauge wire, ANL fuse holder, 100a ANL fuse and JL Bass knob. The system is in perfect working order. The sub has a cosmetic hole in the dust cap, pictured below, IT DOES NOT EFFECT PERFORMANCE WHAT-SO-EVER. The amp shows signs of wear and tear with a few...
  2. M

    Hole in my dust cap 13.5 JL W7

    Yes you are correct. The hole is not in the cone. If i look inside the hole i can see the cone. Im pretty sure this is just for cosmetic... can anyone confirm? The pic below is what my speaker looks like.
  3. M

    Hole in my dust cap 13.5 JL W7

    I have a 13.5 JL W7 which has a hole poked through the dust cap. I have a few questions; Does anyone know where I can get a replacement dust cap? How do i remove the dust cap? Does the hole effect the performance of the sub? Thanks guys.
  4. M

    How much is a 13W7 recone, can i get a kit?

    JL wanted 500 to recone my blown W7. Now i have a 13.5 W7 and i cracked the "dust cap?". Should i just pull the "dust cap" off? Any1 know where ican buy a replacement?
  5. M

    JL 1000/1 Power cables

    Do you possibly have a link?
  6. M

    JL 1000/1 Power cables

    I am looking to upgrade the gauge of my powercables going to my JL 1000/1. I am receiving powerdrops at high volumes but when i jingle the power cable the powerdrops go away, therefore i am attributing the drops to poor wiring. I am going to replace the cable bc i think it is bad, I currently...
  7. M

    Cant power my Jl 1000/1!!! WTF

    Yes im using the factory HU. I have a hi/lo converter maybe i need to tune it. I had this same wiring setup with my last system. A 500/1 and a W6 and i never had cut outs. The Amp is showing a low voltage light so i think its a power issue for sure, but ill check out what you sugested anyway bc...
  8. M

    Cant power my Jl 1000/1!!! WTF

    Im going to shorten up my power and grounds and set the gain properly tonight with the volt meter.
  9. M

    Cant power my Jl 1000/1!!! WTF

    Im just saying i wired the sub at 3ohms. Just trying to give as much info. I just bough a voltmeter, when i get home im going to set the gains. I forgot to menntion the AMP is droping below 11v during the cutoffs, its definitly a power issue.
  10. M

    Cant power my Jl 1000/1!!! WTF

    Firstly my set up. 2009 BMW 335i iDrive w/o logic 7 170-180 Amp Alternator JL Slash 1000/1 JL W7 13.5" wired to 3ohms in a ported 3CFT enclosure. Stock Battery With a secondary Stinger SPV 35 battery connected to the positive of the original battery and grounded to the frame of the car...
  11. M

    JL Audio Gmax vs. 1000.1

    Im a nooob!! Could you please emphasize? What exactly is clipping, i dont know much about it as i have never experienced it before. Why are you certain was it clipping? How can i prevent clipping? Is the sub toast?
  12. M

    JL Audio Gmax vs. 1000.1

    So i got the 1000/1 and i set it all up and cranked it. It was loud and clear but the box was too small. So i disconnected the speaker and amp after cranking it high bass boost and i had the gain set before distortion. I built the box and dropped the w7 in to find out the cone was frozen. I...
  13. M

    JL Audio Gmax vs. 1000.1

    I'm catching a pretty good deal, I'm gettin the 1000.1 for 425 or the gmax for 300. I lost perspective wirh caraudio in terms of money bc I'm always buying JL. I wish o wasn't such a fanboy , same thing with BMW.. It's killing my wallet lol. Thabks for the advice though.
  14. M

    JL Audio Gmax vs. 1000.1

    I'm catching a pretty good deal, I'm gettin the 1000.1 for 425 or the gmax for 300. I lost perspective wirh caraudio in terms of money bc I'm always buying JL. I wish o wasn't such a fanboy , same thing with BMW.. It's killing my wallet lol. Thabks for the advice though.
Top