Recent content by malibujeff

I just bought a CleanSweep CL441dsp today. It will let you use the factory volume controls. It just says the optimum setup is to use the CL441dsp master volume control. You can download the manual from the JL Audio site if you want to read more.

I have been gathering parts for an install. Here is what I have so far: Focal Polyglass 165 V2S Alpine MRV-F357 (80-120W bridged) 1 -JL Audio 10" W3v2-D4 sub This alpine is a 5 channel amp. I am planning to run it bridged to the Focal's and do not plan to have any rear speakers. I'll drive...

bump

Yes, Still looking for a buyer.

Speakers are still available. Not really looking for a trade, but PM me if you have something to trade.

PM sent

PM sent

REDUCED   $100 shipped

Infinity Reference Series 605cs 6-1/2" Component Speaker System Speakers are in very good condition Details: • frequency response 54-20,000 Hz • power range 2-90 watts RMS • peak power handling 270 watts • sensitivity 92 dB • top-mount depth 1-15/16" • Impedance 4 ohms • 1” silk dome...

I have a JL Audio W3v2-D4 10" sub that I am planning to connect to the sub output of an Alpine MRVF357 amp I have. I have never installed a sub before so I have a question about how to wire it up correctly. The manual has 6 different wiring diagrams. 3 wire the voice coils in parallel and 3...

How do you like those memphis m class 6.5's?

I've been planning to use the LC6 when I install an amp with my OEM radio in my 2006 Silverado. I like the LC6 because it can take 4 channels and give you sub out with sub volume control.

I here reading and learning. I just bought a '06 extended cab Silverado and plan to upgrade the speakers and add a sub. I bought a used Alpine MRV-F357 amp and a JL Audio W3v2-D4 10" sub. I found a box to put the sub under the rear seat. Now I am trying to figure out what components to buy...