Recent content by mac336

I have a single 8" w3v3 (ported) hooked up to a slash 500/1 The sub will occasionally cut out and sop working. usually when using the bass boost knob. I've got my amp slope on 12db with filter freq around 60-80 hz input voltage is on low infrasonic filter around 35 hz Over the past couple...

yea, they are legit

So I shouldnt worry about it or be looking for a email shipment confirmation?

Are they legit? I ordered from them days ago. My order is "pending" and they havent replied to my emails. Im getting sketched out

I cant seem to find too many headunits that support FLAC. Any suggestions?

Im using a 8" w3v3 in a ported enclosure. I believe the enclosure is tuned for 34hz. I set my infrasonic filter to 30 hz, this is because I do not want the sub playing frequencies below the box tuning correct? What should I set the LPF at to optimize the sub? Is it dangerous to set the low...

Picked one up today. When I turn it up, my sub gets loud but sounds worse--it sounds grainy and distorted. How can I minimize this?

sealed local or shipped

how much polyfill should I use? how do I get it to stick to the walls of the box?

sub is facing forward in the backseat floor of the car

Mainly because I love how the sealed sounds. The 8w1v2 is inside the cab and plenty loud enough, my only complaint is the lack of low frequency. I dont even want really low freq, just reasonably low but the spl cuts out when it gets lower than midbass I was thinking about going with a small...

My 8w1v2 is currently in a small sealed box. I find that it has trouble maintaining SPL at even the upper end of the low frequencies. Would getting a slightly bigger sealed box help with this? (I believe that the current box its in may be even smaller than what its recommended for).

suitable for a 8" w1v2; black color preferably and dimensions must be less than 17" width/13" height/7" depth

I listen to rock, alternative, and rap. My current 8w1v2 is in a sealed box that is about 12" H, 11"W, 8" depth top/10" depth bottom. I really do love this sub for pretty much everything except when there is a hard bass hit with a strong roll off into the lower frequencies the sub gets quiet...

I plan on going with the JL ported powerwedge box for either the 6" or 8" w3v3. Anyone know how the 2" size difference would sound?