Recent content by lynchmob723

I have 4 6.5 inch speaker holes in my Camaro...Can i get 6.5" subs and have enough bass? I was looking at Tang Bands since every1 seems to rave about them. Would they offer enough bass though?. I know id have to add custom tweeter pods in front, but that is fine. Also what could I do for mid...

ahh good call, thanks

I would still want to block the higher frequencies from going to the sub though right?

Can you do it? I want to run 2 6.5 components in front, and two 8" subs in the back. I would probably have to get a crossover for the subs, but wouldnt it otherwise work? Amp puts out 150x4

really...i compared these side by side at ultimate electronics and I thought the kappas blew the type-r's away...afterwards i remembered that the kappas are 2ohms, and the type-r's are 4ohms....which may have been why I thought that being as they both were being run from the same amp (Im...

http://www.jbl.com/car/products/product_detail.aspx?prod=GTO1020D&ser=GTO&cat=SUB

.6 cu ft box enough for JBL GTO Series?

I have a MOMO enclosure with (.88 cu ft) and a autotek 500.2 amplifier..view amp specs here http://www.sounddomain.com/sku/AUTSS5002 It is 1 ohm stable to my knowledge (500x1). I dont like sloppy bass (So SQ is semi important). I was looking at a HE2, because I can get it cheap. Any other...

Thats weird, ive seen it listed multiple sites as being 1 ohm stable. Hmm

autotek ss 500.2

i cant find where it would say anything anywhere about if its 1ohm stable mono or stereo..all i know is its a 2channel amp that is 1 ohm stable...and shows a rating of 500x1@4ohms mono...this is getting confusing

ok..so lets say this occurs...what could happen?

Would one 12' magnum D2 at 1000watts be just as loud as 2 12' magnum D2 at 500watts each??

Hmm k i see where your going. But Technically, It should split it evenly since the loads are supposedly identical dont ya think? Because the load is what determines the current drop which then determines all your other factors (watts, etc)

why is that not a smart thing to do? seems fine to me. each voice coil will split the watts up evenly, it has to work that way