Recent content by loudproud

Herculiner is by far the best. That stuff is durable as hell. I use it frequently

Alright, I figured it out though. Thanks guys

Thanks man. Like i said, i know HOW to kerf and I can cut kerfs all day long without any blowouts or anything. I just don't know WHEN to start the kerfs for the port bend... Is it like this?

Thanks man. Like i said, i know HOW to kerf and I can cut kerfs all day long without any blowouts or anything. I just don't know WHEN to start the kerfs for the port bend... Is it like this?

I have a question about kerfs. my main question is when to start cutting the kerfs on the front panel for the port bend? Is there some kind of formula to go by? I know how to do kerfs (i'v tested on some pieces) but I dont know where to START the kerfs for the bend... anyone know? I can use...

Hey guys, When using the port length calculator on the12volt.com and it asks you to enter in the box volume, vb, do you enter in the volume after sub displacements? or enter in the box volume before you take into account the sub displacements?

Hey guys, I'm doing a box for my friend and it can only be a certain height. When i design it out the port would have to be 3.5" x 24.5" and gives me around 85 sq. inch. of port. I was just wondering if this ratio would work okay? i heard 1:8 and under would be fine, and in this case it's...

Hey guys, My friend is going to be competing and he wanta a design for his set-up. I was just wondering how boxes for comps are usually designed? are they usually bigger cuft, more port area (16 sqinch. per cube) and higher tuning (40's)? what is usually the difference in size, tuning and port...

actually it was called RTV Black and i heard some good thing about it but its not at my local home depot or lowes i dont think...

Hey guys im looking for some type of adhesive to use on some plexiglass. I am doing something where plexiglass will be "glued" (this is what im looking for) to the mdf (and also have screws). I have heard of some type of stuff called RBK black or something? or is there black sealant out there...

anyone have any suggestions?

I see that many box builders (when they use square terminal cups) and they cut out the square part for the terminal, i was wondering how they get it to be so perfectly square? Is there some kind of guide you use out there for the router? or do they just free hand it with the router and the...

oh ok. so basically the back baffle cut should be cut to whatever the angle of the back needs to be? Thanks

Hi everyone, I'm new to the forum and would like a little bit of guidence I need going to be making a box with a friend and the back baffle needs to be at a 70 degre angle to fit against the back seat. I was wondering what angle the back baffle (the edge that sits on the bottom of the box)...