Recent content by linearpower

The Blues BL6.5 has an Fs of 36 Hz in our component set, and easily plays well below 60 Hz at volume with authority. We have NO problems letting them play full range in the demo or competition vehicles, and with the right amp and door re-inforcement they audibly go into the 20 Hz range. If you...

First off we use a 10% pot instead of the industry standard of 20%, then we match the pots before using them, and our circuit is very closely matched, there is less than 3 millivolts difference at worst case between the tracking of each channel. SECONDLY, we offer the amps with the option of NO...

I would NEVER use a generic ECG/NTE part as a replacement device, there ARE NOT exact replacements. It is always better to use the parts that the factory used. Things such as the bias of the circuit can be miss-matched causing distortion or even failure of the amp again. MCM sells Asian...

This is a very common mode failure on Class D amps.

Sounds like the output fets are dead, or the Class D contoller has died, or it can be a combination of both. The light trying to flash and the fuses not blown generally means the power supply is operational and trying to bring the amp up, but it is in over-current protect from the bad outputs or...

We have been selling the speakers for almost 2 years now. We list max MSRP on our site, Blues Car Audio , and give the dealers a MSRP window to sell them in. We only sell direct from our site at max MSRP and we give our dealers a protected area by US Postal Service Zip Code, and we will not sell...

The only convincing you would need is to hear the difference and it is a big one compared to the others in the same market. A listen is worth a thousand words. We have many seasoned industry professionals shaking their head at what we are achieving with the products, and many converting to our...

We will be indroducing 4 channels , and a 5.1 channel and a version of the 5.1 that will be a self controlled 6 channel. These amps will come later in the year. The 5.1 Channel will use a data cable to connect one connection to the amp and fan out to RCA cables at the other end to hook to the...

We will have a booth with demo vehicles and product to see and hold at SBN 2012. We will also have several contestants competing in the MECA contest.

A watt is a watt, but there are other midigating factors that determine the sound of that watt. Signal to noise ratio, channel separation, headroom, damping factor, transient response, slew rate, distortion (THD and TIM). Quality of sound can only truely be measured by one analog device, the...

Class G/H has its issues, two main ones really. 1. There has to be a peak detect circuit to tell the amp when to change voltage rails, the problem with this is that there is no detection circuit with a high enough slew rate (speed) to swap voltage rails quick enough(it would have to be...

Sorry, I can't get the columns of the chart to work out correctly. It keeps running it all together. First price column is creativecaraudio, second is Zapco home page and third column is woofersinc.

I didn't say Zapco had a $1499.99 110 x 2, the only mention I made to a 110 x 2 was the Tru Technology piece(which I have already posted prices of) because they don't have a 150 x 2. I said the other brands I listed had 150 x 2's starting in the 1499.00 range and up, well that is what I was...

I am looking for where I read the report, I thought it had been Mobile Electronics, it may not have been, hope I can find it. I'm looking back thru all the reading materials here. It may have been from an online source. Matter of fact I am going to retract it till I find the source, given time I...

If you only could hear the difference in the product over the other SQ brands, you would feel it would be worth the money. If Zapco, Tru Technology, Audison, Focal, Mosconi have enough market share I am sure we will find ours too. We have already had the prototypes tested against several of...