Recent content by lifted95

You need ring terminals, firewall grommets, and a blade fuse holder, I'd go with a 10-15A fuse.

I'm going to say 18 or 20. Hard to tell with the small pic.

I'm leaning toward that route, maybe a ZX400 or something, thanks everyone for the help.

True, but I was thinking I might underpower the subs and blow them. what do ya think?

My bad, I have two DVC kicker CVRs at 2ohms per coil.

any non-spillable spiral-cell battery would be ideal.

Ok so I bought the wrong ohm subs and can't return them. (craigslist) I either must run 8-ohm or 2-ohm to the amp. 4 is impossible. My amp is only stable in bridged mode if the resistance is 4 ohms. Am I better of running 8 or are most amps tough enough to run at 2 if I keep the gain down...

haha wow I feel stupid now...thanx

Thanks Squirt, Just what does Sqrt mean? I assume you use the RMS wattage too right?

I was just watching the JL Audio tutorial on setting gains and they cross referenced the Target output voltage. Does RF include that for their amps? Is there a different way to do this? Thanks guys!

I'll pay you to make one for my L5...

2500w is kinda a lot for $350 why not wire the L5s in parallel and run 1500w?

Cool!

I'd say to build it on your computer first, then post up a pic. Thats a ton easier for us then reading all that stuff.

I wanna see the results too! Yea, DEFINATLY get tint!