Recent content by katodevin

I have had nothing but excellent results when using the auto TA as a STARTING point. I find that I have to sometimes tweak the fader to get more of an "up front" sound. Also found that reversing the phase of the sub can help boost the lows, without messing up the flat response too much.

so look for a wire that is 0v at rest, and 12v when the headlights are on?

No, didn't cut it. Testing through the molex plug. No aftermarket harnesses available, so i'm going to be splicing into it. Keeping both factory and additional HU's operational

I'm looking for the wire from my harness that controls illumination. I've found one that is ~5v at rest, and 12v with the headlights on. Is this the proper wire for illumination?

yes.

hahaha, thanks guys. BRRRRRRRRRRRR

im not talking about the speaker not fitting, i'm talking about it smacking into the grill while playing music.

I'm about to install my comps in my doors, but I'm scared that there is not enough clearace for their excursion. Its so hard to tell though, as I can't stick a little camera in there to check once I have the door all put back together? How do you guys tell if you have enough room?

Door Trim Panel Deadening - Even with the stock speakers, when played at anything past a medium volume level, I noticed that the door trim panel and armrest area would vibrate like crazy. I decided to do some deadening action on it. I built up a lot of layers around the speaker grill, just...

Trunk Liner - In my process of deadening the trunk, I decided to add some closed cell foam (Ensolite) to the back of the trunk liner. I used some spray adhesive and did it all in one piece. I tried my best to match all of the contours of the trunk liner, and think it came out pretty good.

I see that Dayton has several lines. Can you guys recommend any specific line to start with? I'm interested specifically in mid-bass woofers. Thanks.

Rear Deck Complete/MDF Ringage - Here is the rear deck put back together with my modified speaker grills. The tweeter's locations look very clean. I cut some MDF rings also for my rear speaker. I decided to go with 2 thin rings for each speaker, and sandwich circles of deadener between...

Driver Teaser - Here's a little teaser. I was very impressed with the quality of the RSD's for the price. I bench tested them outside of an enclosure against the polyglasses. The polyglasses had a a bright and lively sound, also sounded a bit fuller, and were definitely more efficient. The...

Totally with you on your opinion of the sub. I'm pretty ashamed of it. Haha. But it gets the job done for me. I don't push it hard at all, and I rely on the good midbass performance of my front stage more than the sub. It definitely is on my list of upgrades that I should make in the future...

Used this Made by rustoleum. I didn't prep using anything. Stuck to it perfectly fine. The only thing I might do in the future is use some black primer, just to avoid having to do so many coats to hide the wood showing through.