Im pretty sure its going into protect mode.
I guess I could try a new set of RCA's.
On a side not, shouldnt I be able to bridge each sub since I have the front slots open and the slots for the subs.
I figured, the amp is some older big kicker amp....I believe it would be considered a 6 channel amp.
Its only powering 2 rear deck speakers and my 2 12s.
I have always thought the wiring running to it was too small but I dont think that should cause it to go on and off.
I guess its 4 gauge...
So Basically my amp will cut off and back on for a few seconds randomly...
Almost like it was overheating and turning off then back on?
Im not sure what causes it...
Could it be underpowered?
overheating?
weak ground?
Maybe the amp is just on its way out?
Ok, so my plan is to make this box.
http://img77.imageshack.us/img77/8619/43cubes32hz52sqin9ip.png
The only differance is I need to knock the height down a bit.
So I was thinking I would take an inch out of the sides so it would be 15.25 inches tall total.
the sides would now be 20x13.75...