Recent content by juddspaintballs

i got some of the 1/0 from him in the mail today

i need the specs of this sub please

like this? yeah, its more common than routering the lip in actually

use 5/8" all around perhaps. that should give you the airspace you need

Pictures of it all done and put in its place with the materials finally taken out of the Jimmy and the seats put back up. And then a little side project I did today while I was building a box for a friend. This box is .27 cubes and I have a Dayton RS-180 7" 4 ohm woofer in it just for fun.

they are very nice. I could have inset them if I cared, but not really. They're on the back and the slope of the seat (once I finally put the box in position where it should be) will cover the terminals and the box will sit flush against the back of the seats then. I could have also put them...

yes same juddspaintballs, I love my speakers. I wouldn't have survived the almost month without a sub if I didn't have good midbass. The port is 13" long and the box is 20" long...so yes

got mine while it was on sale for $60 at PE. I drove over there and picked one up. So nice to be so close to both their retail stores. I buy scratch and dent stuff as I can afford it too

are you talking about the ends or the couple of spots that it just doesn't fit together right? The ends are like that so it can be carpeted...but I dunno if I'll do that since this is only temporary. I'm getting a Q in the spring hopefully

It was a rushed build. I used 2" brads and liquid nails to hold it together, and my plunge router with Jasper circle jigs for the holes. 3.09 cubes before displacements, 13" round 4" flared port, and a Dayton Quatro 12" woofer. Here's some pictures, not the prettiest looking box ever, but it...

because I was unaware of it at the time

except it needs a double layer to do any good

http://www.lowes.com/lowes/lkn?action=productDetail&productId=154017-81326-PS625

very nice, that is probably what I'll go with next time around. is it thick enough in 1 layer?

doesn't matter if I'm doing my floor. and this isnt peel and seal brand, its different. no foil backing just straight up deadener. got some of the 9" by 50' version on my door panels double layered. hard as hell to peel off actually.