Recent content by joshs9

  1. J

    Wiring Gauge Question

    Thanks for all the answer guys. to N2audio- Just a side question, If i decided to switch to the dual 4 ohm Type R's per say, would the few hundred watts extra for the subs improve SQ at all? with only 50% more power, im not sure the DB gain would be worth it (time and money wise), but if there...
  2. J

    Wiring Gauge Question

    So I have a hifonics 2400.1 running at 2 ohms, 1600 watts. Unfortunately I only installed 4 gauge wire to feed the amp. I've got an 03 impala with the amp in the trunk and the battery at the front, so it's a pretty long run of wire. My question is this- Will I gain any noticeable output by...
  3. J

    Yet another Question about Subwoofer positioning

    It's an 03 impala. Pretty big interior.
  4. J

    250 amp mechman alt for 3800v6

    Would this likely work on an 03 3800 series impala motor?
  5. J

    Yet another Question about Subwoofer positioning

    From what I can tell by the sound it seems to be tuned around the low 40's. There dual 2 ohms wired down to 2 ohms right now. yes I agree that the subs could take lots more power, but i've been trying to avoid needing to do an electrical upgrades, and no I have not done the big 3 yet either, and...
  6. J

    Yet another Question about Subwoofer positioning

    Right now i'm running 2 Type R 12's on a hifonics 2400.1, but at 2 ohms and 1600W, and the box is ported. Its only 1.11 cubes per sub, which I know i quite a bit too small but i've got plans to upgrade it fairly soon. I was curious about this for later on down the road. Also, why would it only...
  7. J

    Yet another Question about Subwoofer positioning

    First off, I've spent a lot of time looking through forums, but this is my first post. Wish me luck. I've done a fair amount of researching and playing around with the positioning of my subs in the trunk in my car, and even a bit with them in the cabin as well. From what I've found, the loudest...
Top