Recent content by johnyboy_10138

  1. J

    Alpine 9886 cutting off and on after KTP-445 installed

    Anyone? I want to make sure I know what I am cutting before I hack up the wiring harness before i start.
  2. J

    Alpine 9886 cutting off and on after KTP-445 installed

    Since the amp is in line with the wiring harness, should i run wire for both sections of the wire, bat to amp, amp to HU? or just run the wire to the amp to by pass the trucks fusebox?
  3. J

    Alpine 9886 cutting off and on after KTP-445 installed

    Hey. So I opted to amp my stock components with an Alpine KTP-445 inline amp. When i turn up the volume on the HU the HU will cut off and turn back on. I replaced the fuse in the HU with a 20 amp fuse and the fuse in the fuse box with a 25 amp fuse. This does not solve the problem. It does...
  4. J

    Dynamat question

    Even with the programmer unloaded, so it is completely stock, it will blow smoke when under load. But all in all. I like they way they look, and that was the driving factor for me.
  5. J

    Stock Infinity Sound System in Ram 2500

    The head unit has a built in crossover to it. I currently have it set to 120hz, as i dont want to blow the speakers. Even with it off, and the subs off, there is no bass. I am going to try out my friends Alpine KTP-445 Power Pack. It plugs into the head units wiring harness. Thanks for the...
  6. J

    Dynamat question

    The truck is a diesel. I like the way it looks coming up through the bed. I trailer my jeep, and I am getting a boat soon. With the exhaust coming out under the rear pump, it dumps the soot out on the jeep and boat. The soot is acidic and can eat through the protective coat. It also makes...
  7. J

    Stock Infinity Sound System in Ram 2500

    So the factory Infinity sound system in my truck used to sound great. It had a factory amp in it, but that had to be taken out when I wired in my new head unit. Now they dont sound nearly as good. I am using an Alpine CDA 9886 head unit. I also have 2 JL10w0 v2 So my question is does anyone...
  8. J

    Dynamat question

    I will looking into the mlv stuff. why?? The same reason anyone puts an exhaust on their car, or runs a few thousand watt system, I like it. Thanks for the info on installation guys.
  9. J

    Dynamat question

    Thanks for the reply. haha, i dont have a cat. But when doing the doors, Is it very important to get the inside panel of the door (the one that is the actually divides the inside and outside)? When doing the floor, is it ok to use like a residential peel and seal product?
  10. J

    Dynamat question

    I have a 2004 Ram 2500. I have my exhaust ran up through my bed and spitting out the smoke behind my rear glass. I have 36 square feet.left, I have done one door. I plan on doing all the doors and then dont know what to do after that. I have resonance coming from the exhaust at certain...
Top