Recent content by jlund10

thanks probably just gonna go with the manuals recomendation

designing a box for a crossfire c7 10" plan on using the recommended 1.5 cf volume and tuning to 35 hz. when i modeled the sub i noticed its ridiculously peaky unless i lower the volume to like 0.8 cf which is insanely low for a ported 10 Where did i f up? could a small mistake in the...

Thanks. does this mean in order to cut my baffle and port to line up perfectly, I just need to use this equation and add it to the total length?

so you’re saying you cut out the bottom piece and mount the kerf part to it first? Tablesaws must make life so much easier

I've watched a couple videos and tried out 90 degree kerf bending, the actual cutting technique makes perfect sense to me. I also understand that in order to get a 3 inch radius, I need 9 inches of total kerf length what I don't get is how to factor the kerf bend into the length of material I...

Trying to get an idea of the best way to install my Lc2i line output converter in my 2015 nissan sentra. I'm planning on using the rear speaker deck since it's nearby where I want to have my sub, only problem is I still have a few wiring questions 1. As you can probably see the speaker wires I...

That sounds like it would boom, I'll have to look into full bridge amps. Only reason I'm trying to stay conservative on power is because I've heard Sentras have weak alternators and I'm not sure how to determine exactly what it can handle.

Thanks for the reply so i take it it's okay to overpower a sub a little?

Hey I'm new to car audio and the forum, I'm trying to put together a solid bass setup for my 2015 nissan sentra for around $500. I'm not looking for anything crazy loud, but I still want something that bumps if that makes sense. I think I'm set on the P3D4 12" by rockford fosgate for the sub...