Yes that is the amp and it does have two sets of terminals. Which I always wondered why, being a monoblock. But i will use both terminals then and run a dedicated line to each enclosure. I tried using a DMM on it an I think my 4 dollar model is reading incorrectly. I tested just one VC and...
So I've checked the wiring guide and I think I have this down. However the separate enclosures I have for each sub is for some reason making me second guess myself.
I have two 4ohm DVC Sundown SD-2 subs. Each in a separate enclosure with its own cup terminal. I will be running them in 1 ohm...
I ended up going with a set from Sky High. Good price and included some heatshrink. I solder all the small wires, but don't have the setup to do wires of this size. I do have a nice hydraulic crimper and I'm my opinion the connections are better than anything I could solder.
I like the Sky...
Hey guys quick question. I have some of the Knu Concepts CCA 1/0 wire. Will be using that for my main run and then OFC 4ga to the amps.
I know the wire is oversized so would like to order some terminals that fit right the first time. I have a hammer crimper, so where is a good place to get them...
Head over to titantalk.com. Plenty of installs and stuff going on over there and knowledgable guys. I have a Titan as well, and use a Pioneer 4600 HU, no RF system, all aftermarket.
Here are the pics. Box has a slant to it at the top, so putting dimensions into a box calculator weren't exact. Looks like .48 cubic feet for internal volume, when I averaged out the height. Mounting depth is 5"
The replacement amp needs to fit in an area 16.5" wide.
They're wired In a bridged setup at 4ohm. I'm going to have to measure the box tomorrow. It's made by tech12v, and each driver has a sealed enclosure. Since it was an underseat enclosure for an ext cab, I'm guessing around .5 for the enclosure.
One thing I will say about the Memphis subs is...
So my amp is having problems. Runs into protect mode whenever an RCA cable is connected to it. Contacted a shop, and they quoted me 50-80 bucks for the repair. Which sounds fair. They also said I need to take a meter to my RCAs and see if there is a problem there, which I plan on doing this...
So I have a Sundown 100.2 amp powering two Memphis 10" subs in a tech12volt under seat box in my Nissan Titan. It has been working fine for over a year now. One day last week it stopped working and I just got around to it yesterday.
Fuses check out. Amp is getting power. Subs wired correctly...
So I have a Sundown 100.2 amp powering two Memphis 10" subs in a tech12volt under seat box in my Nissan Titan. It has been working fine for over a year now. One day last week it stopped working and I just got around to it yesterday.
Fuses check out. Amp is getting power. Subs wired correctly...