Recent content by Jimjam72

  1. J

    reading 20.1 ohms

    Thanks for the advice
  2. J

    reading 20.1 ohms

    Ffg
  3. J

    reading 20.1 ohms

    Hg
  4. J

    reading 20.1 ohms

    My subwoofer is wired positive 2 positive & neg 2 neg into the amplifier not bridged or anything ground wire too the side of the trunk. Bolt down wire to metal 4 gauge power wire and ground wire all gains on amp is right at 50% head unit gains bass/mid at 4 and loud is off on head...
  5. J

    reading 20.1 ohms

    Could this problem with my amplifier going into protection mode be caused FROM miswiring at the head unit (wire harnes)
  6. J

    reading 20.1 ohms

    Could this problem with my amplifier going into protection mode be caused FROM miswiring at the head unit (wire harnes)
  7. J

    reading 20.1 ohms

    Dam... Ok I will you want me tell your mom you said hi..you ****...
  8. J

    reading 20.1 ohms

    Could this problem with my amplifier going into protection mode be caused FROM miswiring at the head unit (wire harnes)
  9. J

    reading 20.1 ohms

    Ok but I have a bigger problem than that the amplifier go in protection mode at high volum with ganes at 50 head un loud is offalso I do not hav the sub bridge have it wired paralle
  10. J

    reading 20.1 ohms

    Yes it was on ..I have it wire with 4 gauge power & ground wire into aftermarket radio unit w/ rca connected to west coast customs amplifier (1600 watt 4 channel) only one subwoofer connected ..but I took the subwoofer out and tested it separate and it read 4 ohms
  11. J

    reading 20.1 ohms

    I'm at work and I tested it twic with a multimete
  12. J

    reading 20.1 ohms

    Sorry about that my amplifier is reading 20.1 ohms subwoofer reads 4 ohms QUOTE=garychoffmann;8722224]The sub is reading 20 ohms? What exactly do you have and how do you have it wired. We can't help anything with "i have 20 ohms, I want 4"
  13. J

    reading 20.1 ohms

    My amplifier is reading at 20.1 ohms need help GETTING to 4 ohms
  14. J

    when pluged into rca output amp goes in protection mode @ high vol

    I have west coast customs1600 4 channel amplifier only one 12 inch hifonics sub right now with 4 gauge powe& ground wire with 100 amp inline fuse. There is no light dimming all levels on the amp is @ 50 % .this only happened after I installed the aftermarket unit
  15. J

    when pluged into rca output amp goes in protection mode @ high vol

    Before I had a rca converter hooked up to my factory radio now I have have an aftermarket uni do I need to disconnect the RCA convert or can I keep it wired a and use my rca on new aftermarket unit
See more
Top
Menu
What's new
Forum list