Recent content by JeffG

What could i put in the kick panels to help the sound quality? I was thinkin of lining the inside with sound deadening then stuffing them with fibre fill. Any comments or suggestions on that?

oops sorry, voice coils in series then subs in parallel

parallel then series for 2 ohm load

300 rms, but i have the gain/input level set a little less than half, the amp supposedly does 1160 @ 2 ohms

Some songs with a lot of bass transitions i guess you would call it, they sound like shit all distorted even at low volume, and also on most songs they sound like they are hitting something even when its not cranked, i don't think its bottoming out though

Well i tried my friends kickers and they seemed to sound normal, so it must be the subs. but do you think they are damaged?

Any1 else have any ideas?

2 ohm DVC, both are wired for a 2 ohm load

Right now i have 2 alpine type r's 12's in a ported box. I originally had an alpine mdr 500 sounded pretty good, then i had a mtx 6500 amp, it pushed them a bit more but still sounded alright. Then i got a RF 1000bd but i had to turn the gain set low and some songs sounded shitty still, most...

well i actually i got my alt rewired for $60 and its 120 at idle and 165 at like 1500 rpm, and i was just makin sure before I installed it back in tomorrow. Thanks for the help.

haha you ^^^^ have a delta 88 too, lol i thought they were extinct, mines a '82 they are boats but reliable, so i guess thats a yes to the wire, 4 or 1 guage? i'm gonna go with 4 because i have some lyin around and maybe do 1 guage later when i get some.

right now there is a 12 gauge wire ging from my alternator to my starter then eventually goes to the positive battery terminal (ends up being really long route) I was wondering if i could just add a 1 or 4 guage wire from alt directly to battery (positive) (like 1.5 ft). The ground for the...