Recent content by jasonlee

I just bought a 2001 sebring and it had amp wires hooked up already. I have two mtx 4500's. I dont have an amp yet. The wire is 4 guage what would happen if I use that wire for an amp that is not as powerful.

I have 2 10inch mtx Thunder 4500 subs in a sealed box. I need some recomendations on some inexspensive amps and where I could find them.Thanx.

I need to replace the rear speakers in my 96 honda accord.they were 6x9's i looked at speakers at a few sites and it says that 6 1/2 's fit..Do i need some mounting kit if i wanted to use this size or do they screw right in? thanx

i have 2 mtx thunder 4500's in a seled box.when i first hooke it up it sounded alright then my amp went into protection mode.know amp stays on but the subs dont sound right. but if i use my hand to put alittle pressure on the silver part of the sub it sounds more like how i want it to sound.what...

for parallel would i put one wire into the pos of channel4 on the amp and the neg wire going into the neg on channel 1.have those wires go to first sub then run another wire going from that subs vc's to the other subs.would this be more power than what i already have hooked up?

im asking which pos and neg on which channel to make it like the diagram in this post http://www.caraudio.com/forum/showthread.php?t=173427

http://www.crutchfield.com/S-IHKVhIJlVrZ/cgi-bin/ProdView.asp?g=520&I=236T4510 these are the subs sorry for th confusion it is just hard for me to explain

sorry the digram didnt post how i wanted it to.it looke diffrent but still crappy before i submitted the post

ok i have 2 subs hooked up to a 4 channel amp i bridged it got 2 speaker wires from each sub going to the amp. if i hook it up parralel there should only be 2 speker wires to hook up to the amp .my question is do i leave it hooked up to where it is now or put the pos or neg to where i had the...

i got 2 y splitters each one has a white and red male end is this the right one?

cool thanx.

should i use the bass boost on my amp? and also i have 2 crossovers on my amp do i witch them 2 hi,flat or low which would be better. i am powering 2 subs

it works now at least for a little bit. i think i had all the levels on the amp theres like 5 of them too high.would that cause it to do that?

it works now at least for a little bit. i think i had all the levels on the amp theres like 5 of them too high.would that cause it to do that?

whats wrong with the sony