Recent content by jake the ssnake

Wow, no wonder it isn't listed. One of those questions "If you have to ask, it's too much". Thanks though, that puts them out of the running for me

Sorry for the thread highjack, but what is the mounting depth on these? I cant find the physical specs/mounting info for the Nightshades line anywhere.

URGGGKKKK, re-read my post I didn't say always or every time, but it usually does. And I think tuning at 35 and peaking at 65 is a little ridiculous:rolleyes: .

Usually the opposite, called "cabin gain". Every vehicle is different obviously, but if you want to peak at 48hz usually you will tune in the lower 40's. My blazer peaks around 50hz so I usually tune around 43-46hz.

I didn't see you mention testing with dmm at the amp (volts), but thats what I'd do. Some gauges are really far off.

Got mine today, good deal . I was worried about it leaking but it was packaged very well.

Did you ever meter your friends setup, I'm getting ready to do that same build (4 type R's/ 2 2006D's)

I had mine "clamped" at this past weekends show. 2 bxi2006d's strapped to 2 type R's D4(via maxx link), which should put them at .5 ohms before rise and all that. This was at the end of the comp, They were warm, subs were warm and it was hot out. But they only put out 2048watts FOR THE PAIR! I...

Thanks, with your help I think I can do better! Nice pic, I was hurting Monday (work at 5:00am FTMFL). I've got a few questions so I'll send you a pm.

I'll give you what you paid for it .

Good times today, set a state record first in my class! Stepped up my #1 spot in midwestspl!

If your still doing this, how much for 3 gallons shipped to 50501?

Right below the battery there are two holes to run in the frame. This is how I ran my ground, if you run your power wires through make sure to use something to protect the wire from rubbing on the hole. This is on a 2001 s10 blazer (the front half of the frame is the same as the trucks) with 2/0...

I would like to see some more "real world" testing/results as well. Fwiw I've been running an 80 amp fuse on both of my bxi-2006's for quite a while( even at a 1/2 ohm strapped for comps), I know its not really an indication of the power they put out but still...

As much as the bxi 2006 can give them, I've never measured it though. But probably somewhere between 8-900 each I'm guessing. And to go even further I used a maxxlink to strap two bxi2006's at .5 ohm a piece for my last competition. So they were seeing probably 1600+ a piece and took it like a...