Recent content by jadyn123

Purchased a new RCA cable and it didn't help. Perhaps I'll try requiring the entire thing, I used the pervious owners wiring. Should I ground the ground wire from the harness directly to the head unit and then run another wire from the head unit to the chassis/body?

Well I tried grounding the RCAs again. All it did was muffle the sound coming out of the speakers. Any other ideas?

Installed a Pioneer head unit a week ago. Has been working fine until yesterday when I started the car it made a loud noise. Later when diagnosing the problem I realized the whine varies by engine rpm. I tried different grounds and grounding the rcas. I dot believe I grounded them right...

Any help? It would be greatly appreciated.

I don't think it's aloose screw

I suppose it could be a hole in the box, but it would need to be near the subwoofer, as the sound is clearly coming from near the sub. As for the surround separating from the cone, wouldn't that be considered a hole? Any ideas to find the hole?

I believe there is a small hole in my new subwoofer. It makes a small noise and a distorts when I turn it up a little loud. The hole is not visible, but when I push on the come you can hear air coming from somewhere. How can I find the hole and how can I fix it? This is a brand new subwoofer...

They are no blown fuses.

Yesterday my amp went into protect mode. I believe it could have been due to heat (I used it for a long time). Now this morning it cooled down and I tried to turn it on. Now the RED LED light, indicating protect mode, does not come on. Nor does the power LED. However a different blue light on...

Well I'm going with a Rockford Fosgate p300-1, & 2 12" Prime R1s. I'll stay under 300$ that way and have a decent amp.

Maybe I should get one 12" CompVR and a Rockford Fosgate 500watt amp instead? That way Ill stay in budget. Will one sub sound good?

Julio, I know what Ohms are, I went through high school physics...

Oh, my bad. They are the 4 Ohms impedance. What about the Rockford Fosgate 300watt class D mono amplifier? Will that be sufficient?

Well, what's a good class D, mono amplifier, that can run these subs, for around 100-120$?

My budget is around 300$. I can't get a better quality amp because I have to put aside ~ 40$ for a Line out Converter and wiring kit & about $50 for a decent Ported box off of amazon. Also, what wiring kit will I need? I noticed there are different gauges, and I don't know what that means.