Recent content by jaden_fackrell

I am about to set-up (2) MTX T9510-44 Series Subs and I am powering them with (2) Mono block Pioneer GM-D510M amps. I was just curious, how I would be able to wire them. I also am putting a 4-Channel amp to power my components and 2-ways. But my HU only has 3 pre-amp outputs. Would this set up...

They are 4 Ohm dvc.

I am looking to put (2) MTX T9510-44 in a sealed fiberglass enclosure, the question is should I use two mono block amps or a two-channel, or bridge a 4-channel amp? The RMS wattage is 750 for each sub, what would be the most practical wattage to run per sub? Any help would be greatly appreciated.

I have read all the sticky's about fiberglassing, I know alot about car audio just have yet to install it all on my own this time. I want to first build around my subs then see what type of power the subs require. I know all about the ft^3 and that just curios as to if it sounds the same as...

What would anyone reccomend for a fiberglass enclosure? I am a complete newb but would rather have a fiberglassed box to save room in my ride. So are there any recommendations? I listen mostly to hip hop and want clean crisp base. Money is no problem either. Any questions just ask.

I am looking at getting 2 12" Memphis m3's. What would be the best type of box for these particular subs? Also what would be a good enough amp(s) to power them both? or I was thinking about using 3 10" MTX 5500 series subs?

I am kinda new at this, put in my old system (comparable to a high-schoolers). I am now looking into putting a new system in my new 2002 Chevy Trailblazer. I have a budget of close to $2,000. Thats with subs, speakers, component speakers, 2 amps, and possibly a EQ. I am looking for some subs...