Recent content by Jackfitz5

Any recommendations for hpf and or sub control setting?

I have had it on the rear, sub setting

What should the hpf setting be? I feel like this is definitely the issue I just can't find the right setting for hpf and subwoofer control. Even when I messed with those settings and put it high up to 200hz I still just have a light hum coming from my sub although it did seem that some bass may...

my head unit is a pioneer deh-150mp. Is a high pass filter like an attachment or just a setting on the headunit?

I figured that but thought it would still be enough to power the amp. It's only 350 w at 4 ohms for the sub channel. It is 2000 w max though. So I will try hooking the head unit up to this battery and the amp to another battery with a full charge and let yall know how that turns out

It's just evident with the sound, movement, etc. The speakers are not in enclosures but the subs are. What is a high pass filter? I'm very new to this.

The amp is getting about 9.5 or 10v according to my multimeter. Do you think that's too low?

It is a pioneer gm-d9605. It has the rca for the sub channel pretty clearly listed. But I will try. I might try taking another battery and have one power my head unit and the other power the amp.

I am bench testing my setup in my room. My setup is a pioneer head unit wired to two Sony xplod in door speakers. (just left front positive and negative) and same with the right. Then I have the red and yellow wire for the head unit twisted together and go to the positive post of the car...

OK so it doesn't matter if my subs are wired to 1 ohm tho correct?

I just noticed that my pioneer head units booklet says that "when speaker output is used by 4 channels, use speakers over 50w and from 4 to 8 ohms. Do not use 1 to 3 ohm speakers for this unit." I have wired my head unit in the standard wire to wire sense. I was planning on running the...

Hi, I am wanting to test some stuff before I install/sell and I would like to do so in the house. I understand that hooking up a car battery charger isn't the best idea because a charging battery will emit hydrogen gas. However, due to the fact that I'm not trying to consistently run a system...

They are svc! I thought 4 ohm svc can't be wired to 2 ohm though?

Great! So my thinking was correct then except for the 650 w max out of that channel it would be 350 to the sub. In that case. Would it be safe to test my subs with said amp? And then I can sell it and get your recommendation. Thanks so much.

Hi, I have recently acquired 4 kicker 12 inch subs model 10c124. They are 4 ohms. Their power handling is 50-150 w rms with a peak of 300. I also got a pioneer amp that I had originally planned on selling but may use to at least test the subs. It is a pioneer gm-d9605. This is a multichannel...