Recent content by Invader_Zim

OK so in Janurary my PCA 2.760 died so i put my Kicker KX 600.1 in and have been using that up until 2 days ago as i got my PCA 2.760 back from being repaired. An hour and a half ago i am heading home from work then it dies AGAIN.. 2days after i put it back in. so i rang the person at the shop...

what kind of fuses are in these amps? blade fuses? if so where do you get 35amp fuses and this is what the amp requires.

yer i disconnected the sub and it's still on protection.

hence the reason i said it was all sweet lol

yer my bad, its series i just checked the diagram i get them confused.

its a a/b (2ohm each channel) and d class (4 ohm bridged) amp. i have a pioneer premier sub dvc 2ohm wired parallel so 4 ohm load so it was all sweet.

so i have this PCA2.760 amp, was driving to work this morning listening to my sounds as i do, then all of a sudden "no bass" pulled over and checked my circuit breaker which was sweet. carried on driving to work as i was 2min away and when i got then i checked the amp and the protection light...

also how do i set the hpf and lpf? i am using a pioneer premier sub with this 2 channel amp.

ok so i rewired this amp into my car because it was in my mates when it died and well it never died at all as it still works so i got off lucky but i've already brought a PCA2.760. turns out the 8gauge wire in my mates car we used 2 run the amp burnt out. lucky there wasn't a fire.

another question. what gauge power wire should i use to be safe?

Hello there. I just brought a Soundstream PCA2.760 amp to replace my kx600.1. i am going to be running a Pioneer Premier ts-w3002spl sub with it and just wonder i am better off bridging the amp or connecting 1 channel to each voice coil? the specs are 380x2 @ 2ohm or 760x1 @ 4ohm bridged, each...

where do i find that?

ok i take it i am going for a new amp.

gain was just under halfway and bass boost was 3/4 up. is there any possibility of it being able to be fixed?

Was running my Pioneer Premier ts-w3002spl with a Kicker 600.1 then just stopped during a song today. from the wiring it looks like it was wired at 1ohm which the amp is not stable with but it ran for a week. it was all hooked up to battery and both power and protection lights don't light up at...