Recent content by hogie roll

I've got two 10" rf punch p3d2s in .59 cu ft enclosures made from 3/4" marine lumber (plastic) aka starboard. I'm getting a nasty like rattle at higher frequencies. Is this the cone or my enclosures rattling against the fiberglass. I doesn't seem to occur at lower frequencies, just high freq...

Guy from PSI got back to me and said he could do a rubberized coating on top of the foam surround and a polypropylene dust cap that covers the entire pulp cone. Pretty cool, maybe when I'm ready to upgrade!

Ordered 2 rockford fosgate p3d2 10s and the cab 1600.1 orders enough starboard to do 2x enclosures. Planning on rf recommended ideal sealed enclosure size of 0.59ft^3, will be a little larger to account for subs. Also ordered four wetsounds xs-65s to be powered by arc pd 2200. I decided I...

Enclosures would look like this Starboard is expensive yeesh. Got me rethinking doing 2x 10s

I said .84 square feet will be my enclosures cross sectional area (csa), so I use that number to calculate my needed enclosure depth based on the sub recommendation. I can not fit a 12 due to it being too wide. I have an 11.25" wide opening that I intend for my enclosure to fit inside of. So...

Sounds like I should plan on two sealed 10s then. I can build the same box for the other side.

Not familiar with that.

Pulp cone, Kevlar reinforced

Is the hcca 104 truly a rubber surround with a .75 cu ft rec ported box volume? https://www.sonicelectronix.com/item_18538_Orion-HCCA104.html I'm seeing it listed elsewhere with a foam surround but the Orion website is worthless from my phone. I like this Dayton ultimax and price, I'd...

They rec .8 min sealed and 1.25 ported for a solobaric 10. SQ ported 2.25 however, which I don't think I can do as it would make the box almost 3' deep and uninstallable

Just saw the recommendation sticky: 1 or 2 10s pref 1 Box size ideally less than 1'^3. CSA will be about .84ftsq so it will get very deep to make a big box. Power, liking that cab 1600 a lot Music, all of it, booty bass included, would like to go deep, get loud and sound good

The leaning post (seat) in the center of the boat firing into the outer wall (gunnel) It has 4 plastic doors. The doors are mounted into openings that measure 11.25" wide and 16" tall with rounded corners. I intend to take the doors and frames out and build a face that screws into the same...

I'm finally ready to upgrade the stereo in my boat, bigly (note to admins, trump is pres now) I'm not interested in using low powered marine free air subs. I intend to build an enclosure out of starboard. I had previously decided I wanted a solobaric due to the plastic polypropylene cone and...