Recent content by GF7PE

Hey everyone, need a hand trying to tune my set up. I am currently using a JLA 500/5 and a 300/4. The sub channel on the 500/5 drives a 10w6ae and I am using the front channel of the 300/4 to drive 2 8.1 micro subs. But I cant seem to get the mid bass covered. I thought by using front...

found it. it was track 41. thanks for the help

ok thanks

Not sure which one it is. I have 3 cd's one says the bass cd, the other says mid bass cd and the other I think says range. I forget, its outside. The Bass Cd has 99 tracks on it

I have a burnt copy of The Bass CD. It the one that has all of the different freq's on it. Does anyone know which track is 50Hz? thanks

any ideas on where to mount tweeters in the back seat of a chevy crew cab? I was thinking in the headliner but...... perfect spot is just behind and above the rear head rests..... just not too keen on puting them behind the passenger

last bench testing on the jl amps I saw were 300/2 making 173 w rms per ch....... 300/4 89.2 w rms per ch......... 500/1 646 w rms per ch....... 1000/1 1480 w rms per ch this is why I went all JL..... blew away the same thing in rf and kicker in the bass room at the local shop granted they are...

you can get them rewound but find a good shop to do it. I had a Jl 500/1 and 300/4 running on the stock alternator with no problems other than a headlight flicker at idle. Last time I saw what you dscribed the amp was wired for briged wrong.

lookin at two different dvd players Alpine IVAD900 and Panasonic CQVAD7300 I am a big alpine fan, its all I have ever had. But there is a $500 difference thoughts? Ideas??? Comments???? others???

I use one of these

hey guys here is the set up 1) JL500/1 1) JL250/1 1) JL300/4 running back to a distribution block I am thinking 1/0 back and then #4's to each also where can I get it by the foot online thanks

I only used it where I had to...goes real fast

check out decent stuff but fiber board not mdf good sound but need to check silicone http://www.subthump.com/achevytruck.htm

can you wire 2 svc subs and 1 dvc sub all 4 ohm off of the same amp parallel

so if a jl250/1 says 1.5-4ohm and 250rms does that mean it will produce the same wattage output within the ohm range?