Recent content by germ.sws

  1. G

    need help with a recon project....

    vc = 2.03" pole od = 1.97" top plate id = 2.09" taken with a micrometer, however the basket has not been separated, so this is as close as i can get for the top plate id and pole od, but i am pretty confident in those measurements. thanks for at least looking at this SPLaudio, i have read a...
  2. G

    need help with a recon project....

    i recently snagged some very old school 10" kicker comp for a very reasonable price. hell, the triple 10 box they came in is worth more than what i paid. so here is my situation... 1 sub has detached from the spider the 2 other subs spiders are very sloppy and loose all 3 subs foam...
  3. G

    need suggestions for an amp.....

    well, i am pretty sure i am going to go with the audiopipe apsm-1200 even though your friend had an issue. there are lots of people on this site that is quite happy with them. sorry your buddy had issues but that could be because of a lot of stuff. i am pretty sure that if there are any...
  4. G

    need suggestions for an amp.....

    ok, i was wondering about that 4th chan thing. why so down on audiopipe? from what i have read around on this site, they are great little amps. they put out rated watts, small size factor, and very affordable. the only thing i have read is that they are a little "dirty" as far sound goes but...
  5. G

    need suggestions for an amp.....

    there are mono amps with that output for roughly that price, example would be a used JBL 600.1, also the audiopipe APSM1200 is under $100 brand new. and as far as what you said about the 4 chan amp, you have me confused because you are not required to bridge the channels to run a sub on any...
  6. G

    need suggestions for an amp.....

    i was also thinking maybe getting a 4 chan amp that can do 100-200 rms per channel but only use 3 channels for the subs. thoughts on this? is is bad to not use 1 channel?
  7. G

    need suggestions for an amp.....

    needing a 1ohm stable mono amp with roughly 300-600max rms output. i am putting together a budget build for my explorer and i already have the subs (3 pioneer 10'' svc 4ohm subs) that are already wired down to 1.33 ohms in the box. i am not partial to any brand, but i would prefer to buy...
  8. G

    Finally got one.

    10's or 12's? (edit, nevermind, i see you said a 15" as i was typing this up) i only ask because there were a couple pairs of them recently on the Minneapolis craigslist and i am from indiana and will be driving back and forth a couple times over the next month. i would only ask for a pair...
  9. G

    Help me choose a SQ Sub

    yes, a week, because i was on vacation. does it matter? and if i were the a$$hole for getting offended because he replied the way he did and i took it the wrong way, then sorry. but honestly, i am pretty sure i didnt take it the wrong way.
  10. G

    Help me choose a SQ Sub

    i was trying help out a$$hole you wanted idea's on decent SQ subs, i had some decent old school SQ subs. all you had to do was say no thanks. instead you were an a$$. good luck trying to get help with a crap attitude like that.
  11. G

    installed new RF amp for door speakers, whirring/clicking sounds

    why not buy a cheap head unit off craigslist and running the setup without the LOC. i am sure you could find and older head unit for less than $50. it will have the correct remote wire and rca hookups. another thought, have you redone your ground to a different location? personally, i prefer...
  12. G

    Help me choose a SQ Sub

    depending on where you are in Wisconsin, I have a pair of old school Infinity Kappa 10"s in a powerwedge box. they are the old school green cones. looking to get $125 if you want to meet up somewhere (im in minneapolis).
  13. G

    10" Infinity Kappa (green) sub, model 100.1se

    bump. i wouldnt be opposed to buying two if you have a pair.
Top