Recent content by Fir3controlman

If i get a second battery where would I put it? I have a ford mustang, so its not like I can put it in the engine space, there is no extra room. Also if I have my car on but not turned over which I need to do sometimes my car will die pretty fast. Its nice to have that switch to turn it off.

1. I have two amps and i need a distribution block for them. I have 4 gauge cable running from my battery but when it splits I'm gonna have an 8 gauge going to my speaker amp and the 4 gauge going to my sub amp is that okay? 2. I have a cap for my sub amp do I put the cap after the DB or before...

So I did what you said with the jumping the car and all and here is what happened: I had a buddy jump my car for about 2 minutes than I started driving it around. About 3 minutes later as I start to slow down to a stop it shuts off on me. Luckily I throw the clutch down and I easily start it...

Okay cool Ill try that out. Also with the cracking in my car speakers. Does that I messed up the neg/pos?

Well I put the key in and the dash lights up but when I turn the key to make the car start it wont. It just makes that clicking noise. It started after I finished putting my speakers in today.

how would I have done that? How would I know if I have

I wired it to the back of my head unit, there was a remote wire on it. It turns off when my car turns off.

(amp) this is my amp connection. I got all four speakers hooked up to them, my remote wire, ground wire, and power connect. (batt) its just my battery cable going to my interior. also is there a simple way to fix my wiring problem without pulling my car apart again?

So I finished wiring my car speakers to my amplifier. Its a 4 channel 600 watt amp that pushes about 45 RMS. I noticed that my left front speaker is making a crackling noise and shortly after realized that I forgot to make sure I connected the pos/neg correctly on my front two speakers. I...

I have 2 JL Audio 10" W6's each pushes 300 rms at 6ohms. What kind of amp should I get to power these?

To misfit : I would love to reply in PM but your storage is full soooo, What amp would power the W6's? How would I install all this? And do I not need a cap or its just not strong enough?

Over the past few weeks I've been buying car stereo parts for my 2000 Ford Mustang and this weekend I will be installing it. I have - 4 6x8 pioneer 40 Watt RMS, 240 Watt max, 4 ohm speakers - 2 JL Audio 10" W6 subwoofers 300 RMS, 6 ohm - Kenwood KAC 8404 600 Watt Max, 50 Watt RMS x 4 (4 ohms)...