Recent content by Enviouswarlock

Thanks for your advises.!

Can anyone recommend a good SPL battery for 4 12's MMATs on a 3500.5. Thank you.

Down to .5 ohms.

Ill probably remove the speakers make sure nothing is touching. That is the last resort.

You know whats odd, When i first set up everything it worked for about half a day then it gave me an issue later that day, Don't think its the set up?

Bass level lowered below 0 mark. Bass boost not on.

Anyone can assist?

ttt

Custom made sealed box. 1 cubic feet as per mmats. Toned to 50hz and gain put down to about 3/4 of full gain. Loud is off and bass boost is also off. When i did a freq tone it helped a little bit but still after a certain volume it starts the distortion. What is a little odd that sometime when...

The odd thing is after i set up everything, Everything worked fine for about half a day bassing like it suppose to then out of no where distortion. Im assuming if it was wired incorrectly then right off the bat it will give me issues

Custom made sealed box. 1 cubic feet as per mmats. Toned to 50hz and gain put down to about 3/4 of full gain. Loud is off and bass boost is also off. When i did a freq tone it helped a little bit but still after a certain volume it starts the distortion. What is a little odd that sometime...

Hello i need a little guidance. I have a d3500.5 series mmats and 4 p.30 12" mmats running at dual 4 ohms and running everything down to 1 ohm. Runs perfect. One small problem i have is after a certain volume the bass sounds distorted and it i can tell it is not giving its full power. I have 2...

Hello i need a little guidance. I have a d3500.5 series mmats and 4 p.30 12" mmats running at dual 4 ohms and running everything down to 1 ohm. Runs perfect. One small problem i have is after a certain volume the bass sounds distorted and it i can tell it is not giving its full power. I have 2...

bump

bump. You know you have one!