Recent content by ender2664

  1. E

    6x9 slope

    The full signal goes to the DSP. The only setting being used on the amp is the accubase.
  2. E

    6x9 slope

    I called CDT, explained my my issue and was told I'd hear back... That was 3 weeks ago.
  3. E

    6x9 slope

    HU to a Musway DSP to a audiocontroll LC6.1200
  4. E

    6x9 slope

    The video isn't fully applicable, but it gets across what I mean by slope.
  5. E

    6x9 slope

    What do you mean by fabrication? Fabricate what?
  6. E

    6x9 slope

    Thank you for the recommendations! With the speaker brackets I have the mounting depth is 4.7", so there is plenty of room in the doors. I should probably mention that I listen to almost all metal, so midbass is very important to me.
  7. E

    6x9 slope

    Yes. They move a lot of air and 8"s don't fit in either location.
  8. E

    6x9 slope

    I have a LC6.1200. Plenty of clean power is getting to the speakers.
  9. E

    6x9 slope

    Thank you :)
  10. E

    6x9 slope

    I don't think most people try to get as much movement out of their speakers as I do, so it isn't too big of a surprise that it isn't listed. Sadly I can't fit a 8" component set in the door :_(
  11. E

    6x9 slope

    xmech?
  12. E

    6x9 slope

    Kicker 47KSS6904 in my front doors and the crossover is at 80hz (I like feeling the air move in my footwell). I have 2 12"s in the trunk.
  13. E

    6x9 slope

    When I set my volume to 70 my system sounds great. When I increase it to 80 my front 6x9s get sloppy/bottom out (for lack of a better term) at lower frequency notes. Changing the slope from 12 to 18 fixes the problem, but I can tell that I like the 12 slope more. Would changing from a kicker KS...
  14. E

    Rear deck 6x9s

    That's why it says REF
  15. E

    Rear deck 6x9s

    Cheap kickers out power focals, I'm not really concerned with the RMS rating.
Top