Recent content by Eddie Jones

I am going to wire the sub in series and get 4 ohms at the terminal. that amp is 275w at 4ohm x 1 so is that about 140 watts per sub? i also plan to add 1 more wired in series so that will drop the amp to 2 ohms.

you are exactly right looked at it and only the inputs are labeled. what would happen if I connect one set of those outputs to a side of the r2d2, and the other output to the other side of the sub?

is a dual coil sub better than single in general?

Can i add a second d2 and get to 2 ohms at the amp

if amp is 1 channel. why do they make 2 outputs on the amp a left and a right?

I am getting a rockford fosgate 10 inch r2d2 it is dual voice coil 2 ohms. when i ordered online i didn't pay attention to that. it is replacing a 4 ohm single voice coil pioneer TS-W253R. is the rockford an upgrade? it will be powered by a phoenix gold qx500.1d. should i show the amp 1 ohm or 4...

--

so i will get full power of the amp if i use either channel?

i want to connect a fosgate r2d2 10 to a phoenix gold qx500.1d. to bridge do i use positive from left channel and negative from right channel?