Recent content by DrSatan

The amp is seeing 2ohms, I think the ground is solid (4gauge) but I will check it again. I have tried it with the gain way down, and still seen it shutdown. Thanks for input bro.

Okay, here’s the scoop. I have my 4 Boston Pro 12’s firing down and they hit hard! But, on certain songs or when they hit REALLY hard and deep my Rockford Fosgate 1500bd shuts down. I think it goes into protection mode and shuts itself off because when I turn the power to it off then back on its...

Once again helotaxi, well said!

Nah i just run 4 of them on one amp and the 4's and tweets off another amp. I am not using the passive crossovers.

Thanks helotaxi, i have always wanted to know that!!! Well done!! What about class B/D, what is a class B/D amp good for?

The 2 best sounding subs i have ever owned= 1. Boston Pro 12LF 2. Kicker Comp. 12

Any idea where i can pick up the modules for the 3XS (other than from the Audio Control website, they want like 20 bucks each.....ya rrrrright)??

What is the size of the box? Is it ported, or sealed? Would help to know that first.

Hey, I have an Audio Control 3XS and I am not sure what module I should use to cross my subs over. Right now I have it set at 33hrz to 90hrz, but my 4 Boston Pro 12's don’t sound right. Anyone have any ideas? Should I go lower like 33 to 60, or maybe take out the 33 and go from 60hrz and below...

No way the guys got 1734 negative feedbacks. Ya rrrrrright

The manual states that with the passive crossovers that it is a 3 ohm load. Wacky huh?

Hey, Does anyone know if the Boston Pro 6.5 is a 4 ohm driver or a 3 ohm driver??(without the passive crossover) I am using an Audio Control 3XS to cross-over my Boston Pro 6.5's and I have two on each side, so I am concerned that if they are a 3ohm driver I am running at 1.5ohm's. I can’t find...

I love my Boston Acoustic 6.53 setup. I listen to hard rock and crank over 500 watts per side to them with no problem. They are kick *** IMO!!!

Hey, Just want to say thanks to everyone who posted. I changed the amount of space in between the subs and the floor to about 41/2 inches and took out ALL of the polyfill. WOW what a difference!!!! This system hits harder than any I have ever had. I have never been metered, but I have to find...

I wish it was the wiring, i triple checked it before i finished the install but ya never know. When i take the polyfill out i will check the wiring again. How much space should i leave for the subs to move? 2 more inches,3? Ayways, thanks for the help guys!