Recent content by desitdt

ENough to do the front two doors and back of an explorer, around 100 sq ft

I would like to know al well

i think i just wired the resistors backwards, ive never wired a relay to work this way and im pretty sure thats what i did.

Hey there i have a 2000 ford explorer and im trying to isolate the door triggers for the alarm activation. I have followed these steps but it still does not work: The BCM is to the left of the radio. Remove the radio and then the two 8mm screws. The dash snaps right off. You can get lights and...

Is that not completely backwards? running them in parallel would give them all the same lowered voltage of the circuit after the resister. You can run 4 3.4 volt leds togeather in series without even usuing a resistor (technically). So wouldnt wiring them in parallel WITH a resister lower the...

Im putting leds in my door switches to change the color to blue. However after doing one door i realized they were WAY to bright and went back and used 2 leds in series connected to one resistor. Shouldnt this decrease the brightness of the Leds? I have one switch with one resistor per led and...

What size is your stock alt?

i have 1/0 everywhere, ive done the big 3...except i didnt see any increase when i did the big 3 :/ and its just before i had 2 kickerl5s off a md2d and my lights dimmed...as well i have alot of leds everywhere and just got some HID fogs.

I have 2 15"s at the moment, running off of a usamp md3d, not at full power at the moment because of electrical, but i only have about $170 that i can spend on wither a battery or an alternator. I cant afford these $300 mechman or irragi alts, e4xpecially not on a 2000 explorer that is slowly...

bump

whats the difference and which is better for car audio?

do you have more 9a31s?

bump...still looking for 30 feet of 1/0 and a fuse holder...atleast need a fuse holder.

ttt

WTB a set of spx-177r crossovers, lmk what ya got