Recent content by ddanko11

with a little router work this is what I came up with guys. Just have to put some carpet on it. Sounds great. thanks for all the input

So I have had two pontiac torrents a 2006 I had a aftermarket stereo, 4 chan, and mono. Now I have a 2007 torrent stock radio, fosgate high low converter, all new fosgate amp and fosgate speakers. Both my cars had a loud hum I cant get rid of. My amp ground is .3 ohm when I check it my high low...

Ok we can agree on the bad thread title. Ok I'll leave the mids in the rear doors connected to the stereo and amp the 4 punch 6.5s; the two already in the front door and the extra pair I have sitting around.

Two sets of punch 6.5 door speakers and a prime 150×2 is what I have just want to make use of it all guys. Was Happy with the sound quality of the 6.5 punches now in the vehicle, just dont want to let the extra pair sit around Under seats not a good spot for them

S

I have filled my rear door spots with mids and the front door with 6.5 punch coax. I want to put another pair of coax 6.5 punch I have sitting around under my rear seat or front seat angled a little so the tweeter points towards the front of my vehicle in my pontiac torrent. Any problems with...

I want to bridge my 4 channle amp but I want to use it for left and right instead of front and rear I'm only concerned about the front stage with my amp and I'll use the the rear output of the radio to power my back door speakers, how would I do that since 1/2 bridged has a left and right and so...

So a while ago I switched out my old car speakers for 2 sets of kicker DS 6.75 coax speakers. i have a 4 channel amp. my pontiac torrent originally came with 2 tweeters one in each of the a pillars and and a 6in midrange  in each door (4 door). i was just wondering would I be better off to run a...

so to decrease that turbulence should i go with a port with less bends and closer to a 1:1 ratio for port L×W if possible 

You know what guys I went out and changed the crossover on my excelon a little bit it sounds a lot more punchy and picked up what it was lacking i dropped the LP to 90hz instead of 120 and the drop off to 24bd instead of 12bd. boosted 160hz 1db. sorry bout that forgot to tune that damn eq

well here is the measurements from sketch up it was actually 35.something, I didn't have access earlier, i was at work. But either way it's just not the same as 15s man especially going from two RE double x 15s

I used sketch up and a port length calculator. I tried ajdesign also. the calculations were very similar between the two 

box is 1.4ft^3 I didn't account for displacement because I wanted it a little smaller. tuned to a 35hz I assume the box got smaller due to disp. so probably tuned a little lower in theory this is what I was going for. port area 12×2  port length 32 box without disp. 1.4 cft

So I've built around ten boxes before and have designed many for my buddies they always were very musical and hit hard all around. (always had 15s) But I've built my first ported enclosure for a 10" skar vvx and It sounds goob except that it really lacks in the punch the really quick bursts of...

So I've built around ten boxes before and have designed many for my buddies they always were very musical and hit hard all around. (always had 15s) But I've built my first ported enclosure for a 10" skar vvx and It sounds goob except that it really lacks in the punch the really quick bursts of...