Recent content by DasDrachen

Yeah I said I did and it came up with about .8 Tomorrow I'm taking out all the wiring, measure the coils again and checking the resistance of each wire.

I used this - How to Tune and Adjust Amplifier Gains and Bass Boost - Knowledge Base - to set them. I'll try this - How to Adjust Amplifier Gains Using a Digital Multi-Meter - Knowledge Base - tomorrow when I have an accurate dmm.

Ok I touched the leads together on the dmm again and it read about .8, so disregarding everything the ohm load is now somewhere around 1. But when I start playing music, it shoots up to ~25 ohms and just fluctuates. Is that normal?

Amp is a DC 1.2k. The dmm also works, I have a couple of them. I've also wired everything so that all I need to do is put the top on the box and call it finished. But when I play music (setting gains) the subs barely play. I tested the terminals where the speaker wire go and it's hitting 20 ohms.

How can I get it to 1 then? Amp says that it's only putting out 700 at 2 ohm

Each is about 4.4 ohm

D4, wired just like this.

I have two DC Audio Level 2 12"s on a 1.2k. I wired them to SonicElectronix and Crutchfield wiring diagrams and both came out to ~1.8 ohm instead of 1. How big of a difference would it be if I left it as it is?

Sounds good. Where can I find fuses though besides online? EDIT: I see BestBuy has some but not sure if they sell in-store. It's a 45 minute drive so I'd like not to go that far just to check.

So what should I get, like a 250?

So I would need one? Well they gave me 350A for 17 feet.

So I have two DC Lvl 2 12"s on a 1.2k, 1/0 power wire along with 1/0 Big 3 wire to a XS Power D3400 battery and a stock alternator from a 93 toyota tercel. I bought the wire in kits from SHCA and I got two 350A fuses with them. Is that too much? Would I need to downsize to at least 300A, or is...

I'm in need of a ported box design for two DC Audio Lvl 2 12's on a 1.2k. It's going in the trunk of my tercel. I have two separate dimensions to compensate for the wheel well. Whichever one offers the best results. I'm looking to get the most bass out of this daily setup. 1: Length ~39"...

Seems like your missing some measurements, and some are off. Or maybe I'm missing something

I have 2 Fi SSD 12s running on a Hifonics Brutus @ 1ohm, and I'm looking for a box for my trunk. I'd like it to be ported too. My max dimensions are Height: 14" Width: 32" & 50" Depth: 33" Here's the reason for two widths- http://i.imgur.com/cyOVi1M.png?1 Thanks guys