Recent content by DARBADARBZ

I have the sub powered by an old 800watt skar amp. I want a 4 channel amp, the tweeters are passive (I think that's the right word) they're wired to the front woofers. Are they really that bad to toss them?

Tacoma Access Cab I have a Kenwood DMX4707S. Rockford Fosgate R169X2 (65W RMS) and Kicker H631SFJ101 (150W RMS) in the front doors. Rockford Fosgate R1675X2 (45W RMS) in the back doors and Hertz MPS 250 (500W RMS) (0.75 cu. ft. sealed) in the back seat. Is this good? Upgrade suggestions? Did...

What makes you say its 400 watts? It says 800. https://www.skaraudio.com/products/svr-10-inch-car-subwoofer

I'll check with multimeter. But no, I actually turned off the bass boost on the hu, made sure the sub was +0 on the hu and made the eq flat.

it was done at a shop and then double checked when I asked them later. Skar RP-800.1D amp

Oh it does stink too. But 2 shops have told me it's fine and I should just turn it down a little. It's an aftermarket Kenwood

This Skar can hit for a little bit, but then it overheats or something and sounds like crap and loses bass. Maybe it was designed for ported so it can have airflow and stay cooler? I'll look into that JL, thanks.

What is the best 10 inch speaker I can put in this box? And how much better will it be than what I have right now? I have this box. It is sealed, with 0.75 cu. ft. of airspace. I have installed in it the Skar SVR-10 D2 (800 RMS). I picked this speaker because the recommended sealed box for the...

My car from factory came with 0 sound deadening material, no fabric or anything in the doors. I have Rockford Fosgate R1675X2 in the back, Rockford Fosgate R169X and Kicker H631SFJ101 in the front. I also have a sealed Skar SVR-10 D2 down firing in the back. I was thinking of sound deadening...

Width is just about 12 inches. Stealth box exists but it's about 1,000 dollars from what I saw. I'm in Boise, ID.

^ edit

2006 Tacoma Access Cab So, I'm using this right now with the VD-8. It just doesn't hit as hard as I want it too. This is what I was thinking of putting the SVR-10 in. But a custom box could be much bigger, maybe big enough for ported? But I would need help, or I'd rather pay someone lol. Like...

SVR-10 is sealed too. I'm hesitantly open to building a box, but it would be my first one I'd need help. Or if someone could make me me one for under $300

Problem is, I have an extended cab pickup truck and I only have 2 options for custom boxes