Recent content by critical

haha ok thanks a lot guys ill try all of this tomorrow or tonight and reply back tomorrow night to let you know if it worked. thanks again

Awsome thanks. What do you recommend out of those 2 diagrams, the 1 ohm load or the 4 ohm load?

2 12 inch RE RE series DVC subs 2 of these: 12” Electrical Q Value -Qes: 0.42 Mechanical Q Value -Qms: 4.27 Total Speaker Q Value -Qts: 0.38 Free Air Resonance -Fs: 20.0 Hz Equivalent Compliance -Vas: 182 liters One-Way, Linear Excursion -Xmax: 12 mm Efficiency -SPL 1W/1m: 87.3 dB SPL...

thx how do i know what ohms i want

1) so if i wired the neg and pos wrong which i think i did....i would still get sound it'd just be distorted and not very much, right? cuz that could be a problem 2)cabin gain...what is that 3) ill check all my wiring but what am i specifically looking for...the pos/neg swtiched around?? and...

I just transfereed my system. It is 2 12 inch dual voice coil RE subs with a pioneer 760 watt amp on a pioneer head unit. I jsut moved it to my new car and left all the options the same on the amp like bass boost and gain. They are wayyy worse quality and quieter than before. The only things I...

make sure you did not blow any fuses and if you did make sure you put big enough ones back in

ok well i dont know what crutchfield is so haha sorry but it should jsut be a simple step taking that bezel off but i dont knwo if there are clips or if i can just put a screw driver behind it and pop it off or what????

can someone answer my last post? thanks

alright cool thanks for the help ... do I just use a screw driver or something to pop that bezel off? and are these the right dash kit and wiring harness i need to add a new deck...

I'm not so samart mokedaddy, what is the "dash bezel" and how do i pull it off? sorry! thanks for help tho!

or is there a way i can just hook my 2 x 12 inch dvc subs up to the stock deck? I just need to connect my amplifier control (blue wire) and my rca cable...would this work with the stock deck? if not, some advice on putting my pioneer in plz thanks guys!

I bought a 2002 ford explorer XLS. I hvae a pioneer deck that i want to install with my speakers...The deck in the explorer is stock and is like one huge piece and it also has a 6 cd changer. I don't even know where to begin...is this going to be a pain in the butt? If anyone has done or knows...

the grounding would explain the noise that varies with rpms but w ould it explain the short lived power to the amp ?

Hooked up my system, and when my deck powers up my blue light on my amp flickers then goes out. I also hear my engine running through my speakers, all kinds of feedback! So, when I unplugg the RCA cables i found out that i no longer here my engine through my car speakers, so i thought that went...