Recent content by cinaibur

Alright. I turned the HPF on and set it to 100Hz, and set the crossovers to -3db. The components sound 1000 times better! I discovered a new problem by doing this though. My sub is not on. How do I diagnose this problem?

Sounds good. I will try all these suggestions when I get home. Just wish it wasn't 112 outside...

They're running bridged on my PDX-5 amp.

Alright. I'll do that when I get home. I have the LPF on the sub set to 100Hz because it is a shallow mount sub in a sealed box in my passenger footwell. Should I set a filter for the 6.5" woofers in the doors? or is that handled by the crossover as well?

Yes. My crossovers have a 0, -1.5, -3, and -4.5. I currently have it on 0. For the module I'm using, the manual says to either use the 0 or the -1.5.

I'll try and get right to the point. This is my new system: Kenwood KIV-BT900 head unit Alpine SPX-17PRO components Alpine PDX-5 Amp Memphis 10" Sub When I turn the volume up to where the sub and my woofers sound good, the tweeters are about to blow my brains out. Should I be making...

Ok. So other than that, I should be good to go with this setup?

SO I am a total car audio noob. I had a basic setup in my Honda Civic: Alpine SPR-17S in the front Alpine SPR-69C in the rear Alpine PDX-4x100 amp Alpine CDA-9883 Head Unit The Civic is being sold and the stereo is going with it, so I am starting over fresh. I just picked up an 07 Honda...