Recent content by CHUMCHAL72

The sub box is actually really close to being done. As u was very limited on space I could only go 16" high. But thanks for the design is plan anyway. It's almost done, tomorrow I'll be painted a little bit for the top design of the box, putting in the cup holders, and carpeting the rest of it...

Allright this is what i got now. what do yall think. I basically opened the port up to 3.5 in, got around 3.5 cubes and scooted the sub over.

Thanks for reply and the tips. I'll redesign and post up whenwhen I get back home. The sub will be down firing. I will add some sort of lift on the bottom of course but I just didn't include it in the design yet

Ok so its my first time building/designing a ported box. Iv'e been researching alot the past couple days and learned a good bit of info. I used the torres box calculator, WinISD, Google Sketchup and also some pen and paper calculations and i think ive almost got it down so heres some specs form...

I'm planning to install 2 amps into my truck but the problem is that I will need an rca for each amp but my head unit only has one output for RCA's is there a splitter or something they have or how have yall put 2 amps up to one head unit Thanks,

Ok thanks with the picture you just put up it would be like putting 2 positive wires in the positive terminal and 2 negative terminals in the negative terminals

Ok so how would I hook up my subs with it them It says I can wire it in parallel and ger the right load of watts so if it's wired internally could I just hook up each sub to each terminal

Then what explains 2 positive terminals and 2 nigitive terminals

Well with just using the one output the way I was told to wire I would get 450w to each sub then turn the gain down So how would I wire with 2 outputs and how much power would I get to each sub

So I have a mono amp and it has 2 sub outputs and I want to wire it to 2 subs So my question is to just use one output and wire it at 2 ohms Or can I use each output to each to each sub and if I can how would I do that and would it be enough power to each sub Here's the specs of the amp/subs...

Thanks some one else told me if I wire my 2 subas and amp at 2 ohm I'll have 900 watts total and 450 to each I think He also said I could just turn my gain down

Just making sure this works before I go spending my money If I wire the mono amp to two subs If I wire the amp to 2 ohm's The amp is * Monoblock Class D Car Amplifier RMS Power Rating (@ 14.4V): 4 ohms: 450 watts x 1 chan. 2 ohms: 900 watts x 1 chan. 1 ohm: 1200 watts x 1 chan. Can I...

Well I got this truck used it used to have a system and the previous owner had cut them

Does it matter it they are cut and reconnected to make them them longer

I was looking at this mono amp but it had 2 speaker outputs. How would I hook it up to 2 subs Speaker outputs - - +. +