Recent content by chinsk

Awesome, I will check that out. Thanks for the reply.

I would like to replace the factory CD player in my 2000 Camry with the Alpine CDA-9813. I know that it is best to wire this headunit directly to the battery with at least a 12 ga cable. I was wondering if any Camry owners out there know of the best way to run this cable fromthe battery to the...

I am looking for some specs and info on this amp. Is anyone familiar with it or know where I can look up info on it?

Also, I haven't torn a Camry apart before and I don't have the car in front of me so I got a few questions regarding the layout of the car. As far as wiring goes, are the speakers powered by an external amp or is the amp internal to the stock headunit? What would you guys recommend as far as...

Another issue I was wondering about was the sub. I plan to keep the Punch HE I had in the Ex and move it to the trunk of the camry. Since the trunk is sealed from the rest of the car I suspect it will not sound the same. I liked the fill the sub had in the explorer and would like to maintain...

You have a model number for those Kappa's and a price by any chance?

I am going to be getting a 2000 Camry some time soon and would like advice on speakers. I currently have a 1993 Explorer with 4 Infinity Reference Series 5x7s in there powered off a Sony CDX-C5000X Head Unit and a RF Punch HE 10 sealed powered by a Sony 150x2 Xplod Amp (This will get comments...

I have a RF punch he 10 in a q logic sealed enclosure (1 ft^3). I want to construct my own and I was wondering about a few points. First, what would be the optimal size for a sealed enclosure for this woofer? The website says recommended is .75 ft^3. Any one have experience with this woofer...

They really arent that horrible of components. A lot of people tend to exagerate.

I have the 150x2 xplod. Out of no where went into offset mode and never functioned the same again. It would keep going into offset no matter what I tried. Took the amp back (best buy service plan) and put in a new one exact model, no problems.

I think the 50hz number maybe the lowest crossover point, not the lowest frequency producable by the amp.

I am currently running a RF Punch HE 10 off a Sony XM-2150GSX amp bridged. The speakers are rated 200 watts RMS and 400 watts peak. The amp says that is puts out 380 watts RMS bridged. Should I be careful about blowin the sub with this setup? I have the 40Hz bass boost set a little above...

the woofer is 4ohm.

I have a Sony XM-2150GSX and I have noticed that it gets extremely hot when running. I have it bridged to one RF HE punch right now. How hot is too hot with these amps? BTW it has thermal protection.

Yeah i know i got 380 into it. I dont really play it at high volumes. Does it push a 380 constantly or only when its cranked? I never understood that concept.