Recent content by ChaseBimmer

The panels are going to be wrapped in suede, and the dash piece painted.

Ok so long story short, the guy who was finishing my panels skipped town for 2 months, and left me with this mess. They cracked while sitting in the garage "I GUESS", and so now I have to figure out how to fix this. Before I pay someone to fix it, I figured I'd ask if you guys thought it would...

Ok so long story short, the guy who was finishing my panels skipped town for 2 months, and left me with this mess. They cracked while sitting in the garage "I GUESS", and so now I have to figure out how to fix this. Before I pay someone to fix it, I figured I'd ask if you guys thought it would...

I need some help on how to get this crap off without ruining the paint on the door. I have to get some off since it shows when the door panel is on.. It is Raamat (Butyl) deadener.. I was thinking some goo gone, but figured I'd post here to ask for suggestions. Any help is appreciated!

Specs, stable at .5? etc.

Trade you an orion 2500d?

Orion 2500d $400

You'll need a good electrical, like you would with any other 3k amp.

bump for an awesome amp

It would be for daily, but it's not going to be run at .5 actually, it will be .7ohms. I am running two 15" fully loaded BL's.

Ok I did search, and haven't found a consistent answer.. what can I expect an Orion 2500d @ .5ohms to be putting out? Electrical is: 250amp iraggi alt kinetic hc800 up front kinetic hc2000 in the rear 2 runs of 1/0 big 3 in 1/0 also

buddy blew 2 at .7ohm, don't do it

keep it.

Pm'd you morgans

bumpp