Recent content by Calenatar

yeah thats the alternator i'm running. would i need to separate them to test that? the rear battery requires pulling my rear seat which is a pain, but obviously i wanna get this fixed. the amp is way more accessible, could i test the power wire at the amp to see the voltage in the wire coming...

So i tested earlier, at idle at the front battery it was sitting at 14.7-14.9, under heavy load from system it would dip to 12.9-13.4. now at the amp under heavy load it would range anywhere from 11.9-12.4 under heavy hits. at both ends of the system between hits it would jump right back to 14+...

I do not, is there somewhere I can monitor with a multi meter?

So i have a 96 impala with a ls2 swap. Has a 270a alternator from https://customelectricservice.com/ Has a xs d3100 in the rear System is 2 sundown zv5 12s hooked up to a crescendo bassclef 4k in a 5cu ft ported box @32hz All power/ground wiring is crescendo 1/0, including big 3 up front...

probably a better idea, trying to avoid pulling the sub box as its god awful heavy, not 100% sure i can get to them from the cabin if i pull the rear seat. will have to check

no, the seats are fixed. the armrest folds down in the center, and behind that is space to create an opening as well. was thinking about putting in 2 big ports in the deck just to simply bleed off pressure from the trunk, but if that wont work like I'm thinking then i'd rather not cut holes in...

This box is pretty much all the space i have. Also have an xs power group 31 back there. Im more wondering if leaving the box as is, and porting the deck would help/change anything or not

So I have a 96 impala SS, in the trunk I have a 5 cu ft ported 32hz box firing towards the rear of the car. has 2 sundown zv5's hooked to an 4k bassclef. Flexes quarter panels, rear seat, and deck very hard. trunk is sealed ish, off from the cabin. I have my rear wheel well mouldings deleted and...

New guy here, I've got a new kicker 12" L7 on its way to me... what amp should I get? I'm not going to be trying to push it hard all the time, but being able to occasionally wake the dead isnt a bad option either. I'm confused on what ohm stability I need because of the DVC thing. I've never...